IB/ipath: Clean up some comments
Signed-off-by: Dave Olson <dave.olson@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/ipath/ipath_driver.c b/drivers/infiniband/hw/ipath/ipath_driver.c
index 7c69090..f130652 100644
--- a/drivers/infiniband/hw/ipath/ipath_driver.c
+++ b/drivers/infiniband/hw/ipath/ipath_driver.c
@@ -1196,7 +1196,7 @@
be32_to_cpu(hdr->bth[0]) & 0xff);
else {
/*
- * error packet, type of error unknown.
+ * error packet, type of error unknown.
* Probably type 3, but we don't know, so don't
* even try to print the opcode, etc.
*/
diff --git a/drivers/infiniband/hw/ipath/ipath_file_ops.c b/drivers/infiniband/hw/ipath/ipath_file_ops.c
index 2a75faf..9e5714d6 100644
--- a/drivers/infiniband/hw/ipath/ipath_file_ops.c
+++ b/drivers/infiniband/hw/ipath/ipath_file_ops.c
@@ -1050,11 +1050,6 @@
phys = dd->ipath_physaddr + piobufs;
- /*
- * Don't mark this as non-cached, or we don't get the
- * write combining behavior we want on the PIO buffers!
- */
-
#if defined(__powerpc__)
/* There isn't a generic way to specify writethrough mappings */
pgprot_val(vma->vm_page_prot) |= _PAGE_NO_CACHE;
diff --git a/drivers/infiniband/hw/ipath/ipath_iba6110.c b/drivers/infiniband/hw/ipath/ipath_iba6110.c
index ce85879..dffb682 100644
--- a/drivers/infiniband/hw/ipath/ipath_iba6110.c
+++ b/drivers/infiniband/hw/ipath/ipath_iba6110.c
@@ -1022,7 +1022,8 @@
do {
u8 cap_type;
- /* the HT capability type byte is 3 bytes after the
+ /*
+ * The HT capability type byte is 3 bytes after the
* capability byte.
*/
if (pci_read_config_byte(pdev, pos + 3, &cap_type)) {
diff --git a/drivers/infiniband/hw/ipath/ipath_iba6120.c b/drivers/infiniband/hw/ipath/ipath_iba6120.c
index 97ae117..66925b2 100644
--- a/drivers/infiniband/hw/ipath/ipath_iba6120.c
+++ b/drivers/infiniband/hw/ipath/ipath_iba6120.c
@@ -535,7 +535,7 @@
if (hwerrs & INFINIPATH_HWE_SERDESPLLFAILED) {
/*
- * If it occurs, it is left masked since the eternal
+ * If it occurs, it is left masked since the external
* interface is unused
*/
dd->ipath_hwerrmask &= ~INFINIPATH_HWE_SERDESPLLFAILED;
diff --git a/drivers/infiniband/hw/ipath/ipath_keys.c b/drivers/infiniband/hw/ipath/ipath_keys.c
index 85a4aef..8f32b17 100644
--- a/drivers/infiniband/hw/ipath/ipath_keys.c
+++ b/drivers/infiniband/hw/ipath/ipath_keys.c
@@ -128,9 +128,8 @@
int ret;
/*
- * We use LKEY == zero to mean a physical kmalloc() address.
- * This is a bit of a hack since we rely on dma_map_single()
- * being reversible by calling bus_to_virt().
+ * We use LKEY == zero for kernel virtual addresses
+ * (see ipath_get_dma_mr and ipath_dma.c).
*/
if (sge->lkey == 0) {
struct ipath_pd *pd = to_ipd(qp->ibqp.pd);
diff --git a/drivers/infiniband/hw/ipath/ipath_verbs.c b/drivers/infiniband/hw/ipath/ipath_verbs.c
index a2baa61..904ff15 100644
--- a/drivers/infiniband/hw/ipath/ipath_verbs.c
+++ b/drivers/infiniband/hw/ipath/ipath_verbs.c
@@ -943,7 +943,7 @@
* ipath_verbs_send - send a packet
* @qp: the QP to send on
* @hdr: the packet header
- * @hdrwords: the number of words in the header
+ * @hdrwords: the number of 32-bit words in the header
* @ss: the SGE to send
* @len: the length of the packet in bytes
*/
@@ -955,7 +955,10 @@
int ret;
u32 dwords = (len + 3) >> 2;
- /* +1 is for the qword padding of pbc */
+ /*
+ * Calculate the send buffer trigger address.
+ * The +1 counts for the pbc control dword following the pbc length.
+ */
plen = hdrwords + dwords + 1;
/* Drop non-VL15 packets if we are not in the active state */