spi: spi-imx: only enable the clocks when we start to transfer a message
Current code keeps the clocks enabled all the time, it wastes the power
when there is no operaiton on the spi controller.
In order to save the power, this patch adds the two hooks:
spi_imx_prepare_message: enable the clocks for this message
spi_imx_unprepare_message: disable the clocks.
This patch also disables the clocks in the end of the probe.
Signed-off-by: Huang Shijie <b32955@freescale.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c
index 15323d8..cc9defe 100644
--- a/drivers/spi/spi-imx.c
+++ b/drivers/spi/spi-imx.c
@@ -749,6 +749,35 @@
{
}
+static int
+spi_imx_prepare_message(struct spi_master *master, struct spi_message *msg)
+{
+ struct spi_imx_data *spi_imx = spi_master_get_devdata(master);
+ int ret;
+
+ ret = clk_enable(spi_imx->clk_per);
+ if (ret)
+ return ret;
+
+ ret = clk_enable(spi_imx->clk_ipg);
+ if (ret) {
+ clk_disable(spi_imx->clk_per);
+ return ret;
+ }
+
+ return 0;
+}
+
+static int
+spi_imx_unprepare_message(struct spi_master *master, struct spi_message *msg)
+{
+ struct spi_imx_data *spi_imx = spi_master_get_devdata(master);
+
+ clk_disable(spi_imx->clk_ipg);
+ clk_disable(spi_imx->clk_per);
+ return 0;
+}
+
static int spi_imx_probe(struct platform_device *pdev)
{
struct device_node *np = pdev->dev.of_node;
@@ -810,6 +839,8 @@
spi_imx->bitbang.txrx_bufs = spi_imx_transfer;
spi_imx->bitbang.master->setup = spi_imx_setup;
spi_imx->bitbang.master->cleanup = spi_imx_cleanup;
+ spi_imx->bitbang.master->prepare_message = spi_imx_prepare_message;
+ spi_imx->bitbang.master->unprepare_message = spi_imx_unprepare_message;
spi_imx->bitbang.master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH;
init_completion(&spi_imx->xfer_done);
@@ -872,6 +903,8 @@
dev_info(&pdev->dev, "probed\n");
+ clk_disable(spi_imx->clk_ipg);
+ clk_disable(spi_imx->clk_per);
return ret;
out_clk_put: