| |
| #ifndef _I386_HPET_H |
| #define _I386_HPET_H |
| |
| #ifdef CONFIG_HPET_TIMER |
| |
| #include <linux/errno.h> |
| #include <linux/module.h> |
| #include <linux/sched.h> |
| #include <linux/kernel.h> |
| #include <linux/param.h> |
| #include <linux/string.h> |
| #include <linux/mm.h> |
| #include <linux/interrupt.h> |
| #include <linux/time.h> |
| #include <linux/delay.h> |
| #include <linux/init.h> |
| #include <linux/smp.h> |
| |
| #include <asm/io.h> |
| #include <asm/smp.h> |
| #include <asm/irq.h> |
| #include <asm/msr.h> |
| #include <asm/delay.h> |
| #include <asm/mpspec.h> |
| #include <asm/uaccess.h> |
| #include <asm/processor.h> |
| |
| #include <linux/timex.h> |
| #include <linux/config.h> |
| |
| #include <asm/fixmap.h> |
| |
| /* |
| * Documentation on HPET can be found at: |
| * http://www.intel.com/ial/home/sp/pcmmspec.htm |
| * ftp://download.intel.com/ial/home/sp/mmts098.pdf |
| */ |
| |
| #define HPET_MMAP_SIZE 1024 |
| |
| #define HPET_ID 0x000 |
| #define HPET_PERIOD 0x004 |
| #define HPET_CFG 0x010 |
| #define HPET_STATUS 0x020 |
| #define HPET_COUNTER 0x0f0 |
| #define HPET_T0_CFG 0x100 |
| #define HPET_T0_CMP 0x108 |
| #define HPET_T0_ROUTE 0x110 |
| #define HPET_T1_CFG 0x120 |
| #define HPET_T1_CMP 0x128 |
| #define HPET_T1_ROUTE 0x130 |
| #define HPET_T2_CFG 0x140 |
| #define HPET_T2_CMP 0x148 |
| #define HPET_T2_ROUTE 0x150 |
| |
| #define HPET_ID_LEGSUP 0x00008000 |
| #define HPET_ID_NUMBER 0x00001f00 |
| #define HPET_ID_REV 0x000000ff |
| #define HPET_ID_NUMBER_SHIFT 8 |
| |
| #define HPET_CFG_ENABLE 0x001 |
| #define HPET_CFG_LEGACY 0x002 |
| #define HPET_LEGACY_8254 2 |
| #define HPET_LEGACY_RTC 8 |
| |
| #define HPET_TN_ENABLE 0x004 |
| #define HPET_TN_PERIODIC 0x008 |
| #define HPET_TN_PERIODIC_CAP 0x010 |
| #define HPET_TN_SETVAL 0x040 |
| #define HPET_TN_32BIT 0x100 |
| |
| /* Use our own asm for 64 bit multiply/divide */ |
| #define ASM_MUL64_REG(eax_out,edx_out,reg_in,eax_in) \ |
| __asm__ __volatile__("mull %2" \ |
| :"=a" (eax_out), "=d" (edx_out) \ |
| :"r" (reg_in), "0" (eax_in)) |
| |
| #define ASM_DIV64_REG(eax_out,edx_out,reg_in,eax_in,edx_in) \ |
| __asm__ __volatile__("divl %2" \ |
| :"=a" (eax_out), "=d" (edx_out) \ |
| :"r" (reg_in), "0" (eax_in), "1" (edx_in)) |
| |
| #define KERNEL_TICK_USEC (1000000UL/HZ) /* tick value in microsec */ |
| /* Max HPET Period is 10^8 femto sec as in HPET spec */ |
| #define HPET_MAX_PERIOD (100000000UL) |
| /* |
| * Min HPET period is 10^5 femto sec just for safety. If it is less than this, |
| * then 32 bit HPET counter wrapsaround in less than 0.5 sec. |
| */ |
| #define HPET_MIN_PERIOD (100000UL) |
| |
| extern unsigned long hpet_tick; /* hpet clks count per tick */ |
| extern unsigned long hpet_address; /* hpet memory map physical address */ |
| extern int hpet_use_timer; |
| |
| extern int hpet_rtc_timer_init(void); |
| extern int hpet_enable(void); |
| extern int hpet_reenable(void); |
| extern int is_hpet_enabled(void); |
| extern int is_hpet_capable(void); |
| extern int hpet_readl(unsigned long a); |
| |
| #ifdef CONFIG_HPET_EMULATE_RTC |
| extern int hpet_mask_rtc_irq_bit(unsigned long bit_mask); |
| extern int hpet_set_rtc_irq_bit(unsigned long bit_mask); |
| extern int hpet_set_alarm_time(unsigned char hrs, unsigned char min, unsigned char sec); |
| extern int hpet_set_periodic_freq(unsigned long freq); |
| extern int hpet_rtc_dropped_irq(void); |
| extern int hpet_rtc_timer_init(void); |
| extern irqreturn_t hpet_rtc_interrupt(int irq, void *dev_id, struct pt_regs *regs); |
| #endif /* CONFIG_HPET_EMULATE_RTC */ |
| #endif /* CONFIG_HPET_TIMER */ |
| #endif /* _I386_HPET_H */ |