[media] m88ds3103: calculate DiSEqC message sending time
DiSEqC message sending takes 13.5 ms per byte, which is 54 ms total
when typical 4 byte message is sent. Don't hard-code time limit to
54 ms, but calculate it. Time limit is only used to determine when to
start poll "DiSEqC Tx ready" status from the chip.
Signed-off-by: Antti Palosaari <crope@iki.fi>
Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com>
diff --git a/drivers/media/dvb-frontends/m88ds3103.c b/drivers/media/dvb-frontends/m88ds3103.c
index 7c19601..6f03ca8 100644
--- a/drivers/media/dvb-frontends/m88ds3103.c
+++ b/drivers/media/dvb-frontends/m88ds3103.c
@@ -1116,8 +1116,9 @@
#define SEND_MASTER_CMD_TIMEOUT 120
timeout = jiffies + msecs_to_jiffies(SEND_MASTER_CMD_TIMEOUT);
- /* DiSEqC message typical period is 54 ms */
- usleep_range(50000, 54000);
+ /* DiSEqC message period is 13.5 ms per byte */
+ utmp = diseqc_cmd->msg_len * 13500;
+ usleep_range(utmp - 4000, utmp);
for (utmp = 1; !time_after(jiffies, timeout) && utmp;) {
ret = regmap_read(dev->regmap, 0xa1, &utmp);