sata_promise: don't classify overruns as HSM errors
When sata_promise encounters an overrun or underrun error it
translates that to a libata AC_ERR_HSM, causing a hard reset.
Since over/under-runs were thought to be rare and transient,
this action seemed reasonable.
Unfortunately it turns out that the controller throws overrun
errors when e.g. hal polls a CD or DVD writer containing blank
media, causing long sequences of hard resets and retries before
EH finally gives up.
This patch updates sata_promise to classify over/under-runs as
AC_ERR_OTHER instead. This allows libata EH and upper layers to
retry or fail the operation as they see fit without the disruption
caused by repeated hard resets.
This fixes a problem using a DVD-RAM drive with sata_promise,
reported by Thomas Schorpp. I also tested it on a DVD-RW drive.
Signed-off-by: Mikael Pettersson <mikpe@it.uu.se>
Tested-by: thomas schorpp <thomas.schorpp@googlemail.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
diff --git a/drivers/ata/sata_promise.c b/drivers/ata/sata_promise.c
index 07d8d00..6330628 100644
--- a/drivers/ata/sata_promise.c
+++ b/drivers/ata/sata_promise.c
@@ -862,7 +862,7 @@
if (port_status & PDC_DRIVE_ERR)
ac_err_mask |= AC_ERR_DEV;
if (port_status & (PDC_OVERRUN_ERR | PDC_UNDERRUN_ERR))
- ac_err_mask |= AC_ERR_HSM;
+ ac_err_mask |= AC_ERR_OTHER;
if (port_status & (PDC2_ATA_HBA_ERR | PDC2_ATA_DMA_CNT_ERR))
ac_err_mask |= AC_ERR_ATA_BUS;
if (port_status & (PDC_PH_ERR | PDC_SH_ERR | PDC_DH_ERR | PDC2_HTO_ERR