[netdrvr] natsemi: minor cleanups
* make eeprom size a variable, prepping for future patch
* eliminate unused PCI_xxx stuff left over from Becker driver template
* convert a few #defines to enum
* mark PCI table const, __devinitdata
* don't bother with named constant for PCI device id
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/natsemi.c b/drivers/net/natsemi.c
index 5dc4146..5657049 100644
--- a/drivers/net/natsemi.c
+++ b/drivers/net/natsemi.c
@@ -226,7 +226,6 @@
NATSEMI_PG1_NREGS)
#define NATSEMI_REGS_VER 1 /* v1 added RFDR registers */
#define NATSEMI_REGS_SIZE (NATSEMI_NREGS * sizeof(u32))
-#define NATSEMI_DEF_EEPROM_SIZE 24 /* 12 16-bit values */
/* Buffer sizes:
* The nic writes 32-bit values, even if the upper bytes of
@@ -344,18 +343,6 @@
-enum pcistuff {
- PCI_USES_IO = 0x01,
- PCI_USES_MEM = 0x02,
- PCI_USES_MASTER = 0x04,
- PCI_ADDR0 = 0x08,
- PCI_ADDR1 = 0x10,
-};
-
-/* MMIO operations required */
-#define PCI_IOTYPE (PCI_USES_MASTER | PCI_USES_MEM | PCI_ADDR1)
-
-
/*
* Support for fibre connections on Am79C874:
* This phy needs a special setup when connected to a fibre cable.
@@ -363,22 +350,25 @@
*/
#define PHYID_AM79C874 0x0022561b
-#define MII_MCTRL 0x15 /* mode control register */
-#define MII_FX_SEL 0x0001 /* 100BASE-FX (fiber) */
-#define MII_EN_SCRM 0x0004 /* enable scrambler (tp) */
+enum {
+ MII_MCTRL = 0x15, /* mode control register */
+ MII_FX_SEL = 0x0001, /* 100BASE-FX (fiber) */
+ MII_EN_SCRM = 0x0004, /* enable scrambler (tp) */
+};
/* array of board data directly indexed by pci_tbl[x].driver_data */
static const struct {
const char *name;
unsigned long flags;
+ unsigned int eeprom_size;
} natsemi_pci_info[] __devinitdata = {
- { "NatSemi DP8381[56]", PCI_IOTYPE },
+ { "NatSemi DP8381[56]", 0, 24 },
};
-static struct pci_device_id natsemi_pci_tbl[] = {
- { PCI_VENDOR_ID_NS, PCI_DEVICE_ID_NS_83815, PCI_ANY_ID, PCI_ANY_ID, },
- { 0, },
+static const struct pci_device_id natsemi_pci_tbl[] __devinitdata = {
+ { PCI_VENDOR_ID_NS, 0x0020, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
+ { } /* terminate list */
};
MODULE_DEVICE_TABLE(pci, natsemi_pci_tbl);
@@ -888,8 +878,7 @@
iosize = pci_resource_len(pdev, pcibar);
irq = pdev->irq;
- if (natsemi_pci_info[chip_idx].flags & PCI_USES_MASTER)
- pci_set_master(pdev);
+ pci_set_master(pdev);
dev = alloc_etherdev(sizeof (struct netdev_private));
if (!dev)
@@ -928,7 +917,7 @@
np->msg_enable = (debug >= 0) ? (1<<debug)-1 : NATSEMI_DEF_MSG;
np->hands_off = 0;
np->intr_status = 0;
- np->eeprom_size = NATSEMI_DEF_EEPROM_SIZE;
+ np->eeprom_size = natsemi_pci_info[chip_idx].eeprom_size;
/* Initial port:
* - If the nic was configured to use an external phy and if find_mii