IB/ipath: Add the work completion error code to the QP error debug output
Add the work completion error code to the QP error debug output.
This makes it easier to determine the cause of the error.
Signed-off-by: Ralph Campbell <ralph.campbell@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/ipath/ipath_qp.c b/drivers/infiniband/hw/ipath/ipath_qp.c
index b997ff88..b405906 100644
--- a/drivers/infiniband/hw/ipath/ipath_qp.c
+++ b/drivers/infiniband/hw/ipath/ipath_qp.c
@@ -387,8 +387,8 @@
struct ib_wc wc;
int ret = 0;
- ipath_dbg("QP%d/%d in error state\n",
- qp->ibqp.qp_num, qp->remote_qpn);
+ ipath_dbg("QP%d/%d in error state (%d)\n",
+ qp->ibqp.qp_num, qp->remote_qpn, err);
spin_lock(&dev->pending_lock);
/* XXX What if its already removed by the timeout code? */