net/mlx4_core: Fix checking order in MR table init
In procedure mlx4_init_mr_table(), slaves should do no processing,
but should return success. This initialization is hypervisor-only.
However, the check for num_mpts being a power-of-2 was performed
before the check to return immediately if the driver is for a slave.
This resulted in spurious failures.
The order of performing the checks is reversed, so that if the
driver is for a slave, no processing is done and success is returned.
Signed-off-by: Jack Morgenstein <jackm@dev.mellanox.co.il>
Signed-off-by: Or Gerlitz <ogerlitz@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/mellanox/mlx4/mr.c b/drivers/net/ethernet/mellanox/mlx4/mr.c
index f91719a..63391a1 100644
--- a/drivers/net/ethernet/mellanox/mlx4/mr.c
+++ b/drivers/net/ethernet/mellanox/mlx4/mr.c
@@ -755,14 +755,14 @@
struct mlx4_mr_table *mr_table = &priv->mr_table;
int err;
- if (!is_power_of_2(dev->caps.num_mpts))
- return -EINVAL;
-
/* Nothing to do for slaves - all MR handling is forwarded
* to the master */
if (mlx4_is_slave(dev))
return 0;
+ if (!is_power_of_2(dev->caps.num_mpts))
+ return -EINVAL;
+
err = mlx4_bitmap_init(&mr_table->mpt_bitmap, dev->caps.num_mpts,
~0, dev->caps.reserved_mrws, 0);
if (err)