i40e: Fix an issue when PF reset fails
We shouldn't restart Admin queue subtask if PF reset fails since we do
not have the AQ setup at that point. This patch makes sure we disable AQ
clean subtask when PF reset fails.
This will resolve an occasional kernel panic when PF reset fails for
some reason.
Change-ID: I11a747773362a8c5c0ad7a10cd34be0bda8eb9e8
Signed-off-by: Anjali Singhai Jain <anjali.singhai@intel.com>
Tested-by: Jim Young <jamesx.m.young@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/i40e/i40e_main.c b/drivers/net/ethernet/intel/i40e/i40e_main.c
index 55a31ab..64b8683 100644
--- a/drivers/net/ethernet/intel/i40e/i40e_main.c
+++ b/drivers/net/ethernet/intel/i40e/i40e_main.c
@@ -5568,6 +5568,10 @@
u32 oldval;
u32 val;
+ /* Do not run clean AQ when PF reset fails */
+ if (test_bit(__I40E_RESET_FAILED, &pf->state))
+ return;
+
/* check for error indications */
val = rd32(&pf->hw, pf->hw.aq.arq.len);
oldval = val;
@@ -5973,19 +5977,20 @@
ret = i40e_pf_reset(hw);
if (ret) {
dev_info(&pf->pdev->dev, "PF reset failed, %d\n", ret);
- goto end_core_reset;
+ set_bit(__I40E_RESET_FAILED, &pf->state);
+ goto clear_recovery;
}
pf->pfr_count++;
if (test_bit(__I40E_DOWN, &pf->state))
- goto end_core_reset;
+ goto clear_recovery;
dev_dbg(&pf->pdev->dev, "Rebuilding internal switch\n");
/* rebuild the basics for the AdminQ, HMC, and initial HW switch */
ret = i40e_init_adminq(&pf->hw);
if (ret) {
dev_info(&pf->pdev->dev, "Rebuild AdminQ failed, %d\n", ret);
- goto end_core_reset;
+ goto clear_recovery;
}
/* re-verify the eeprom if we just had an EMP reset */
@@ -6103,6 +6108,8 @@
i40e_send_version(pf);
end_core_reset:
+ clear_bit(__I40E_RESET_FAILED, &pf->state);
+clear_recovery:
clear_bit(__I40E_RESET_RECOVERY_PENDING, &pf->state);
}