drm/i915: Set the LVDS_BORDER when using LVDS scaling mode
According to the spec the LVDS_BORDER_ENABLE bit decides whether the border
data should be included in the active display and data sent to the panel.
Border should be used when in VGA centered (un-scaled) mode or when scaling
a 4:3 source image to a wide screen panel (typical 16:9).
So when the LVDS scaling is used, decide whether the LVDS_BORDER should be
enabled or not according to the current scaling mode.
At the same time fix the typo error in LVDS center scaling mode.
https://bugs.freedesktop.org/show_bug.cgi?id=23789
Signed-off-by: Zhao Yakui <yakui.zhao@intel.com>
tested-by: Zhao Jian <jian.zhao@intel.com>
Signed-off-by: Eric Anholt <eric@anholt.net>
diff --git a/drivers/gpu/drm/i915/intel_lvds.c b/drivers/gpu/drm/i915/intel_lvds.c
index 98ae3d7..089f18c 100644
--- a/drivers/gpu/drm/i915/intel_lvds.c
+++ b/drivers/gpu/drm/i915/intel_lvds.c
@@ -380,7 +380,7 @@
adjusted_mode->crtc_vblank_start + vsync_pos;
/* keep the vsync width constant */
adjusted_mode->crtc_vsync_end =
- adjusted_mode->crtc_vblank_start + vsync_width;
+ adjusted_mode->crtc_vsync_start + vsync_width;
border = 1;
break;
case DRM_MODE_SCALE_ASPECT:
@@ -526,6 +526,14 @@
lvds_priv->pfit_control = pfit_control;
lvds_priv->pfit_pgm_ratios = pfit_pgm_ratios;
/*
+ * When there exists the border, it means that the LVDS_BORDR
+ * should be enabled.
+ */
+ if (border)
+ dev_priv->lvds_border_bits |= LVDS_BORDER_ENABLE;
+ else
+ dev_priv->lvds_border_bits &= ~(LVDS_BORDER_ENABLE);
+ /*
* XXX: It would be nice to support lower refresh rates on the
* panels to reduce power consumption, and perhaps match the
* user's requested refresh rate.