mmc: sdhci: check voltage range only on regulators aware of voltage value
Some regulators don't report any voltage values, so checking supported
voltage range results in disabling all SDHCI_CAN_VDD_* flags and
registration failure. This patch finally provides a correct fix for the
registration of SDHCI driver with all possible voltage regulators:
dummy, fixed and regulated without using regulator_count_voltages()
hacks.
Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
Signed-off-by: Chris Ball <cjb@laptop.org>
diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index ba586ae..735526b 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -2976,7 +2976,11 @@
}
#ifdef CONFIG_REGULATOR
- if (host->vmmc) {
+ /*
+ * Voltage range check makes sense only if regulator reports
+ * any voltage value.
+ */
+ if (host->vmmc && regulator_get_voltage(host->vmmc) > 0) {
ret = regulator_is_supported_voltage(host->vmmc, 2700000,
3600000);
if ((ret <= 0) || (!(caps[0] & SDHCI_CAN_VDD_330)))