USB: Add call to notify xHC of a device reset.
Add a new host controller driver method, reset_device(), that the USB core
will use to notify the host of a successful device reset. The call may
fail due to out-of-memory errors; attempt the port reset sequence again if
that happens. Update hub_port_init() to allow resetting a configured
device.
Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c
index 20ecb4c..bb416cd 100644
--- a/drivers/usb/core/hub.c
+++ b/drivers/usb/core/hub.c
@@ -2008,7 +2008,9 @@
struct usb_device *udev, unsigned int delay)
{
int i, status;
+ struct usb_hcd *hcd;
+ hcd = bus_to_hcd(udev->bus);
/* Block EHCI CF initialization during the port reset.
* Some companion controllers don't like it when they mix.
*/
@@ -2036,6 +2038,14 @@
/* TRSTRCY = 10 ms; plus some extra */
msleep(10 + 40);
update_address(udev, 0);
+ if (hcd->driver->reset_device) {
+ status = hcd->driver->reset_device(hcd, udev);
+ if (status < 0) {
+ dev_err(&udev->dev, "Cannot reset "
+ "HCD device state\n");
+ break;
+ }
+ }
/* FALL THROUGH */
case -ENOTCONN:
case -ENODEV:
@@ -2645,14 +2655,7 @@
mutex_lock(&usb_address0_mutex);
- if ((hcd->driver->flags & HCD_USB3) && udev->config) {
- /* FIXME this will need special handling by the xHCI driver. */
- dev_dbg(&udev->dev,
- "xHCI reset of configured device "
- "not supported yet.\n");
- retval = -EINVAL;
- goto fail;
- } else if (!udev->config && oldspeed == USB_SPEED_SUPER) {
+ if (!udev->config && oldspeed == USB_SPEED_SUPER) {
/* Don't reset USB 3.0 devices during an initial setup */
usb_set_device_state(udev, USB_STATE_DEFAULT);
} else {