regulator: palmas: fix regmap offsets for enable/disable
I forgot to apply the offsets for the regmap helper functions for
enable/disable on SMPS10 and the LDO regulators. This means regulators
will not enable/disable correctly.
Signed-off-by: Graeme Gregory <gg@slimlogic.co.uk>
Tested-by: Sebastien Guiriec <s-guiriec@ti.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
diff --git a/drivers/regulator/palmas-regulator.c b/drivers/regulator/palmas-regulator.c
index 9b7ca90..795f75a 100644
--- a/drivers/regulator/palmas-regulator.c
+++ b/drivers/regulator/palmas-regulator.c
@@ -673,7 +673,9 @@
pmic->desc[id].ops = &palmas_ops_smps10;
pmic->desc[id].vsel_reg = PALMAS_SMPS10_CTRL;
pmic->desc[id].vsel_mask = SMPS10_VSEL;
- pmic->desc[id].enable_reg = PALMAS_SMPS10_STATUS;
+ pmic->desc[id].enable_reg =
+ PALMAS_BASE_TO_REG(PALMAS_SMPS_BASE,
+ PALMAS_SMPS10_STATUS);
pmic->desc[id].enable_mask = SMPS10_BOOST_EN;
}
@@ -739,7 +741,8 @@
pmic->desc[id].type = REGULATOR_VOLTAGE;
pmic->desc[id].owner = THIS_MODULE;
- pmic->desc[id].enable_reg = palmas_regs_info[id].ctrl_addr;
+ pmic->desc[id].enable_reg = PALMAS_BASE_TO_REG(PALMAS_LDO_BASE,
+ palmas_regs_info[id].ctrl_addr);
pmic->desc[id].enable_mask = PALMAS_LDO1_CTRL_MODE_ACTIVE;
if (pdata && pdata->reg_data)