rt2800: 5592: BBP registers initialization
Based on:
NICInitRT5592BbpRegisters()
NICInitBBP()
from:
DPO_RT5572_LinuxSTA_2.6.1.3_20121022/chips/rt5592.c
DPO_RT5572_LinuxSTA_2.6.1.3_20121022/common/rtmp_init.c
Signed-off-by: Stanislaw Gruszka <stf_xl@wp.pl>
Tested-by: Wanlong Gao <gaowanlong@cn.fujitsu.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/rt2x00/rt2800.h b/drivers/net/wireless/rt2x00/rt2800.h
index acb5e62..9d18d53 100644
--- a/drivers/net/wireless/rt2x00/rt2800.h
+++ b/drivers/net/wireless/rt2x00/rt2800.h
@@ -90,11 +90,8 @@
#define REV_RT3390E 0x0211
#define REV_RT5390F 0x0502
#define REV_RT5390R 0x1502
+#define REV_RT5592C 0x0221
-/*
- * Signal information.
- * Default offset is required for RSSI <-> dBm conversion.
- */
#define DEFAULT_RSSI_OFFSET 120
/*
@@ -1956,6 +1953,20 @@
#define BBP49_UPDATE_FLAG FIELD8(0x01)
/*
+ * BBP 105:
+ * - bit0: detect SIG on primary channel only (on 40MHz bandwidth)
+ * - bit1: FEQ (Feed Forward Compensation) for independend streams
+ * - bit2: MLD (Maximum Likehood Detection) for 2 streams (reserved on single
+ * stream)
+ * - bit4: channel estimation updates based on remodulation of
+ * L-SIG and HT-SIG symbols
+ */
+#define BBP105_DETECT_SIG_ON_PRIMARY FIELD8(0x01)
+#define BBP105_FEQ FIELD8(0x02)
+#define BBP105_MLD FIELD8(0x04)
+#define BBP105_SIG_REMODULATION FIELD8(0x08)
+
+/*
* BBP 109
*/
#define BBP109_TX0_POWER FIELD8(0x0f)
@@ -1975,6 +1986,11 @@
#define BBP152_RX_DEFAULT_ANT FIELD8(0x80)
/*
+ * BBP 254: unknown
+ */
+#define BBP254_BIT7 FIELD8(0x80)
+
+/*
* RFCSR registers
* The wordsize of the RFCSR is 8 bits.
*/