phylib: Allow early-out in phy_change
Marvell 88E1121R Dual PHY device can be hardware-configured
to use shared interrupt pin for both PHY ports. For such
PHY configurations using shared PHY interrupt phy_interrupt()
handler will also schedule a work for PHY port which didn't
cause an interrupt.
This patch adds a possibility for PHY drivers to provide
did_interrupt() function which reports if the PHY (or a PHY
port in a multi-PHY device) generated an interrupt. This
function is called in phy_change() as phy_change() shouldn't
proceed if it is invoked for a PHY which didn't cause an
interrupt. So check for interrupt originator in phy_change()
to allow early-out.
Signed-off-by: Anatolij Gustschin <agust@denx.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/phy/phy.c b/drivers/net/phy/phy.c
index 3ff1f42..e3b8932 100644
--- a/drivers/net/phy/phy.c
+++ b/drivers/net/phy/phy.c
@@ -655,6 +655,10 @@
struct phy_device *phydev =
container_of(work, struct phy_device, phy_queue);
+ if (phydev->drv->did_interrupt &&
+ !phydev->drv->did_interrupt(phydev))
+ goto ignore;
+
err = phy_disable_interrupts(phydev);
if (err)
@@ -681,6 +685,11 @@
return;
+ignore:
+ atomic_dec(&phydev->irq_disable);
+ enable_irq(phydev->irq);
+ return;
+
irq_enable_err:
disable_irq(phydev->irq);
atomic_inc(&phydev->irq_disable);
diff --git a/include/linux/phy.h b/include/linux/phy.h
index 32cf14a..97e40cb 100644
--- a/include/linux/phy.h
+++ b/include/linux/phy.h
@@ -388,6 +388,12 @@
/* Enables or disables interrupts */
int (*config_intr)(struct phy_device *phydev);
+ /*
+ * Checks if the PHY generated an interrupt.
+ * For multi-PHY devices with shared PHY interrupt pin
+ */
+ int (*did_interrupt)(struct phy_device *phydev);
+
/* Clears up any memory if needed */
void (*remove)(struct phy_device *phydev);