avr32: Add MMIO address definitions for certain controllers
Hardcoded MMIO base addresses are used a few places throughout the
platform code. Move these into the chip-specific header file so that
adding support for new chips becomes a bit easier.
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
diff --git a/arch/avr32/mach-at32ap/pm.h b/arch/avr32/mach-at32ap/pm.h
index 694d521..532a373 100644
--- a/arch/avr32/mach-at32ap/pm.h
+++ b/arch/avr32/mach-at32ap/pm.h
@@ -4,14 +4,6 @@
#ifndef __ARCH_AVR32_MACH_AT32AP_PM_H__
#define __ARCH_AVR32_MACH_AT32AP_PM_H__
-/*
- * We can reduce the code size a bit by using a constant here. Since
- * this file is only used on AVR32 AP CPUs with segmentation enabled,
- * it's safe to not use ioremap. Generic drivers should of course
- * never do this.
- */
-#define AT32_PM_BASE 0xfff00000
-
/* PM register offsets */
#define PM_MCCTRL 0x0000
#define PM_CKSEL 0x0004
@@ -113,8 +105,8 @@
/* Register access macros */
#define pm_readl(reg) \
- __raw_readl((void __iomem __force *)AT32_PM_BASE + PM_##reg)
+ __raw_readl((void __iomem __force *)PM_BASE + PM_##reg)
#define pm_writel(reg,value) \
- __raw_writel((value), (void __iomem __force *)AT32_PM_BASE + PM_##reg)
+ __raw_writel((value), (void __iomem __force *)PM_BASE + PM_##reg)
#endif /* __ARCH_AVR32_MACH_AT32AP_PM_H__ */