[libata] use dev_printk() throughout drivers
A few drivers were not following the standard meme of printing out
their driver name and version at module load time; this is fixed
as well.
diff --git a/drivers/scsi/sata_mv.c b/drivers/scsi/sata_mv.c
index 936d1ce..46dbdee 100644
--- a/drivers/scsi/sata_mv.c
+++ b/drivers/scsi/sata_mv.c
@@ -29,6 +29,7 @@
#include <linux/interrupt.h>
#include <linux/sched.h>
#include <linux/dma-mapping.h>
+#include <linux/device.h>
#include "scsi.h"
#include <scsi/scsi_host.h>
#include <linux/libata.h>
@@ -1437,9 +1438,9 @@
else
scc_s = "unknown";
- printk(KERN_INFO DRV_NAME
- "(%s) %u slots %u ports %s mode IRQ via %s\n",
- pci_name(pdev), (unsigned)MV_MAX_Q_DEPTH, probe_ent->n_ports,
+ dev_printk(KERN_INFO, &pdev->dev,
+ "%u slots %u ports %s mode IRQ via %s\n",
+ (unsigned)MV_MAX_Q_DEPTH, probe_ent->n_ports,
scc_s, (MV_HP_FLAG_MSI & hpriv->hp_flags) ? "MSI" : "INTx");
}
@@ -1460,9 +1461,8 @@
void __iomem *mmio_base;
int pci_dev_busy = 0, rc;
- if (!printed_version++) {
- printk(KERN_INFO DRV_NAME " version " DRV_VERSION "\n");
- }
+ if (!printed_version++)
+ dev_printk(KERN_INFO, &pdev->dev, "version " DRV_VERSION "\n");
rc = pci_enable_device(pdev);
if (rc) {