ARM: dts: DRA74x: Add IPC sub-mailbox nodes for all IPUs & DSPs
Add the sub-mailbox nodes that are used to communicate between
MPU and the remote processors IPU1, IPU2, DSP1 and DSP2.
The sub-mailbox nodes utilize the System Mailbox instances 5 and 6.
These sub-mailbox nodes are added to match the hard-coded mailbox
configuration used within the TI IPC 3.x software package. The
Dual-Cortex M4 IPU1 and IPU2 processor sub-systems are assumed to
be running in SMP-mode, and hence only a single sub-mailbox node
is added for each.
All these sub-mailbox nodes are left in disabled state, and should
be enabled (and modified if needed) as per the individual product
configuration in the corresponding board dts files.
Signed-off-by: Suman Anna <s-anna@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/boot/dts/dra74x.dtsi b/arch/arm/boot/dts/dra74x.dtsi
index feea98e..33d11c2 100644
--- a/arch/arm/boot/dts/dra74x.dtsi
+++ b/arch/arm/boot/dts/dra74x.dtsi
@@ -93,3 +93,29 @@
<&dss_video2_clk>;
clock-names = "fck", "video1_clk", "video2_clk";
};
+
+&mailbox5 {
+ mbox_ipu1_ipc3x: mbox_ipu1_ipc3x {
+ ti,mbox-tx = <6 2 2>;
+ ti,mbox-rx = <4 2 2>;
+ status = "disabled";
+ };
+ mbox_dsp1_ipc3x: mbox_dsp1_ipc3x {
+ ti,mbox-tx = <5 2 2>;
+ ti,mbox-rx = <1 2 2>;
+ status = "disabled";
+ };
+};
+
+&mailbox6 {
+ mbox_ipu2_ipc3x: mbox_ipu2_ipc3x {
+ ti,mbox-tx = <6 2 2>;
+ ti,mbox-rx = <4 2 2>;
+ status = "disabled";
+ };
+ mbox_dsp2_ipc3x: mbox_dsp2_ipc3x {
+ ti,mbox-tx = <5 2 2>;
+ ti,mbox-rx = <1 2 2>;
+ status = "disabled";
+ };
+};