USB: OHCI: Properly handle ohci-at91 suspend
Suspend scenario in case of ohci-at91 glue was not properly handled
as it was not suspending generic part of ohci controller. Alan Stern
suggested, properly handle ohci-at91 suspend scenario.
Calling explicitly the ohci_suspend() routine in ohci_hcd_at91_drv_suspend()
will ensure proper handling of suspend scenario. This task is sugested
by Alan Stern.
Signed-off-by: Manjunath Goudar <csmanjuvijay@gmail.com>
Acked-by: Alan Stern <stern@rowland.harvard.edu>
Cc: Arnd Bergmann <arnd@arndb.de>
Cc: linux-usb@vger.kernel.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/host/ohci-at91.c b/drivers/usb/host/ohci-at91.c
index 418444e..cc9462f 100644
--- a/drivers/usb/host/ohci-at91.c
+++ b/drivers/usb/host/ohci-at91.c
@@ -635,10 +635,17 @@
{
struct usb_hcd *hcd = platform_get_drvdata(pdev);
struct ohci_hcd *ohci = hcd_to_ohci(hcd);
+ bool do_wakeup = device_may_wakeup(&pdev->dev);
+ int ret;
- if (device_may_wakeup(&pdev->dev))
+ if (do_wakeup)
enable_irq_wake(hcd->irq);
+ ret = ohci_suspend(hcd, do_wakeup);
+ if (ret) {
+ disable_irq_wake(hcd->irq);
+ return ret;
+ }
/*
* The integrated transceivers seem unable to notice disconnect,
* reconnect, or wakeup without the 48 MHz clock active. so for
@@ -657,7 +664,7 @@
at91_stop_clock();
}
- return 0;
+ return ret;
}
static int ohci_hcd_at91_drv_resume(struct platform_device *pdev)