usb: xhci: use bus->sysdev for DMA configuration
For xhci-hcd platform device, all the DMA parameters are not
configured properly, notably dma ops for dwc3 devices. So, set
the dma for xhci from sysdev. sysdev is pointing to device that
is known to the system firmware or hardware.
Cc: Baolin Wang <baolin.wang@linaro.org>
Tested-by: Alexander Sverdlin <alexander.sverdlin@nokia.com>
Tested-by: Vivek Gautam <vivek.gautam@codeaurora.org>
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Sriram Dash <sriram.dash@nxp.com>
Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com>
Signed-off-by: Peter Chen <peter.chen@nxp.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Change-Id: I5a909abc30a101dcbd4b8f495a360e8dc46377bc
Git-commit: 4c39d4b949d36faffbc726525b469886cf311d1c
Git-repo: git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/usb.git
[jackp@codeaurora.org: additional fixups to secondary ring functions]
Signed-off-by: Jack Pham <jackp@codeaurora.org>
diff --git a/drivers/usb/host/xhci-mem.c b/drivers/usb/host/xhci-mem.c
index be0a89e..374750f 100644
--- a/drivers/usb/host/xhci-mem.c
+++ b/drivers/usb/host/xhci-mem.c
@@ -586,7 +586,7 @@
unsigned int num_stream_ctxs,
struct xhci_stream_ctx *stream_ctx, dma_addr_t dma)
{
- struct device *dev = xhci_to_hcd(xhci)->self.controller;
+ struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
size_t size = sizeof(struct xhci_stream_ctx) * num_stream_ctxs;
if (size > MEDIUM_STREAM_ARRAY_SIZE)
@@ -614,7 +614,7 @@
unsigned int num_stream_ctxs, dma_addr_t *dma,
gfp_t mem_flags)
{
- struct device *dev = xhci_to_hcd(xhci)->self.controller;
+ struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
size_t size = sizeof(struct xhci_stream_ctx) * num_stream_ctxs;
if (size > MEDIUM_STREAM_ARRAY_SIZE)
@@ -1678,7 +1678,7 @@
static int scratchpad_alloc(struct xhci_hcd *xhci, gfp_t flags)
{
int i;
- struct device *dev = xhci_to_hcd(xhci)->self.controller;
+ struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
int num_sp = HCS_MAX_SCRATCHPAD(xhci->hcs_params2);
xhci_dbg_trace(xhci, trace_xhci_dbg_init,
@@ -1750,7 +1750,7 @@
{
int num_sp;
int i;
- struct device *dev = xhci_to_hcd(xhci)->self.controller;
+ struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
if (!xhci->scratchpad)
return;
@@ -1903,7 +1903,7 @@
{
int size;
struct xhci_hcd *xhci = hcd_to_xhci(hcd);
- struct device *dev = xhci_to_hcd(xhci)->self.controller;
+ struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
if (intr_num >= xhci->max_interrupters) {
xhci_err(xhci, "invalid secondary interrupter num %d\n",
@@ -1935,7 +1935,7 @@
{
int size;
unsigned int i;
- struct device *dev = xhci_to_hcd(xhci)->self.controller;
+ struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
/* sec event ring clean up */
for (i = 1; i < xhci->max_interrupters; i++)
@@ -1963,7 +1963,7 @@
void xhci_mem_cleanup(struct xhci_hcd *xhci)
{
- struct device *dev = xhci_to_hcd(xhci)->self.controller;
+ struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
int i, j, num_ports;
cancel_delayed_work_sync(&xhci->cmd_timer);
@@ -2475,7 +2475,7 @@
u64 val_64;
unsigned int val;
struct xhci_segment *seg;
- struct device *dev = xhci_to_hcd(xhci)->self.controller;
+ struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
*er = xhci_ring_alloc(xhci, ERST_NUM_SEGS, 1, TYPE_EVENT, 0, flags);
if (!*er)
@@ -2641,7 +2641,7 @@
int xhci_mem_init(struct xhci_hcd *xhci, gfp_t flags)
{
dma_addr_t dma;
- struct device *dev = xhci_to_hcd(xhci)->self.controller;
+ struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
unsigned int val, val2;
u64 val_64;
u32 page_size, temp;
diff --git a/drivers/usb/host/xhci-plat.c b/drivers/usb/host/xhci-plat.c
index ec1f0b9..f33f972 100644
--- a/drivers/usb/host/xhci-plat.c
+++ b/drivers/usb/host/xhci-plat.c
@@ -14,6 +14,7 @@
#include <linux/clk.h>
#include <linux/dma-mapping.h>
#include <linux/module.h>
+#include <linux/pci.h>
#include <linux/of.h>
#include <linux/platform_device.h>
#include <linux/usb/phy.h>
@@ -139,6 +140,7 @@
{
const struct of_device_id *match;
const struct hc_driver *driver;
+ struct device *sysdev;
struct xhci_hcd *xhci;
struct resource *res;
struct usb_hcd *hcd;
@@ -155,22 +157,39 @@
if (irq < 0)
return -ENODEV;
+ /*
+ * sysdev must point to a device that is known to the system firmware
+ * or PCI hardware. We handle these three cases here:
+ * 1. xhci_plat comes from firmware
+ * 2. xhci_plat is child of a device from firmware (dwc3-plat)
+ * 3. xhci_plat is grandchild of a pci device (dwc3-pci)
+ */
+ sysdev = &pdev->dev;
+ if (sysdev->parent && !sysdev->of_node && sysdev->parent->of_node)
+ sysdev = sysdev->parent;
+#ifdef CONFIG_PCI
+ else if (sysdev->parent && sysdev->parent->parent &&
+ sysdev->parent->parent->bus == &pci_bus_type)
+ sysdev = sysdev->parent->parent;
+#endif
+
/* Try to set 64-bit DMA first */
- if (WARN_ON(!pdev->dev.dma_mask))
+ if (WARN_ON(!sysdev->dma_mask))
/* Platform did not initialize dma_mask */
- ret = dma_coerce_mask_and_coherent(&pdev->dev,
+ ret = dma_coerce_mask_and_coherent(sysdev,
DMA_BIT_MASK(64));
else
- ret = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(64));
+ ret = dma_set_mask_and_coherent(sysdev, DMA_BIT_MASK(64));
/* If seting 64-bit DMA mask fails, fall back to 32-bit DMA mask */
if (ret) {
- ret = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(32));
+ ret = dma_set_mask_and_coherent(sysdev, DMA_BIT_MASK(32));
if (ret)
return ret;
}
- hcd = usb_create_hcd(driver, &pdev->dev, dev_name(&pdev->dev));
+ hcd = __usb_create_hcd(driver, sysdev, &pdev->dev,
+ dev_name(&pdev->dev), NULL);
if (!hcd)
return -ENOMEM;
@@ -224,7 +243,7 @@
xhci->clk = clk;
xhci->main_hcd = hcd;
- xhci->shared_hcd = usb_create_shared_hcd(driver, &pdev->dev,
+ xhci->shared_hcd = __usb_create_hcd(driver, sysdev, &pdev->dev,
dev_name(&pdev->dev), hcd);
if (!xhci->shared_hcd) {
ret = -ENOMEM;
@@ -233,10 +252,10 @@
hcd_to_bus(xhci->shared_hcd)->skip_resume = true;
- if (device_property_read_bool(&pdev->dev, "usb3-lpm-capable"))
+ if (device_property_read_bool(sysdev, "usb3-lpm-capable"))
xhci->quirks |= XHCI_LPM_SUPPORT;
- hcd->usb_phy = devm_usb_get_phy_by_phandle(&pdev->dev, "usb-phy", 0);
+ hcd->usb_phy = devm_usb_get_phy_by_phandle(sysdev, "usb-phy", 0);
if (IS_ERR(hcd->usb_phy)) {
ret = PTR_ERR(hcd->usb_phy);
if (ret == -EPROBE_DEFER)
diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c
index 64daa09..e6e985d 100644
--- a/drivers/usb/host/xhci.c
+++ b/drivers/usb/host/xhci.c
@@ -231,6 +231,9 @@
static int xhci_setup_msi(struct xhci_hcd *xhci)
{
int ret;
+ /*
+ * TODO:Check with MSI Soc for sysdev
+ */
struct pci_dev *pdev = to_pci_dev(xhci_to_hcd(xhci)->self.controller);
ret = pci_enable_msi(pdev);
@@ -257,7 +260,7 @@
*/
static void xhci_free_irq(struct xhci_hcd *xhci)
{
- struct pci_dev *pdev = to_pci_dev(xhci_to_hcd(xhci)->self.controller);
+ struct pci_dev *pdev = to_pci_dev(xhci_to_hcd(xhci)->self.sysdev);
int ret;
/* return if using legacy interrupt */
@@ -743,7 +746,7 @@
struct xhci_hcd *xhci = hcd_to_xhci(hcd);
if (xhci->quirks & XHCI_SPURIOUS_REBOOT)
- usb_disable_xhci_ports(to_pci_dev(hcd->self.controller));
+ usb_disable_xhci_ports(to_pci_dev(hcd->self.sysdev));
spin_lock_irq(&xhci->lock);
xhci_halt(xhci);
@@ -760,7 +763,7 @@
/* Yet another workaround for spurious wakeups at shutdown with HSW */
if (xhci->quirks & XHCI_SPURIOUS_WAKEUP)
- pci_set_power_state(to_pci_dev(hcd->self.controller), PCI_D3hot);
+ pci_set_power_state(to_pci_dev(hcd->self.sysdev), PCI_D3hot);
}
#ifdef CONFIG_PM
@@ -4821,7 +4824,11 @@
int xhci_gen_setup(struct usb_hcd *hcd, xhci_get_quirks_t get_quirks)
{
struct xhci_hcd *xhci;
- struct device *dev = hcd->self.controller;
+ /*
+ * TODO: Check with DWC3 clients for sysdev according to
+ * quirks
+ */
+ struct device *dev = hcd->self.sysdev;
int retval;
/* Accept arbitrarily long scatter-gather lists */