ARM: mx3/mx35_3ds: add usb host2 support
we still have to toggle two pins on the mc9sdz60:
/* MUX3_CTR to be low for USB Host2 DP&DM */
pmic_gpio_set_bit_val(MCU_GPIO_REG_GPIO_CONTROL_2, 6, 0);
/* CAN_PWDN to be high for USB Host2 Power&OC */
pmic_gpio_set_bit_val(MCU_GPIO_REG_GPIO_CONTROL_2, 1, 1);
until we've a proper driver for the mx9sdz60 in linux we'll do this in
barebox (a.k.a. u-boot-v2)
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
Signed-off-by: Michael Grzeschik <m.grzeschik@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
diff --git a/arch/arm/mach-mx3/mach-mx35_3ds.c b/arch/arm/mach-mx3/mach-mx35_3ds.c
index ae0f17c..1dd7baae 100644
--- a/arch/arm/mach-mx3/mach-mx35_3ds.c
+++ b/arch/arm/mach-mx3/mach-mx35_3ds.c
@@ -38,6 +38,7 @@
#include <mach/hardware.h>
#include <mach/common.h>
#include <mach/iomux-mx35.h>
+#include <mach/mxc_ehci.h>
#include "devices-imx35.h"
#include "devices.h"
@@ -105,6 +106,9 @@
/* USBOTG */
MX35_PAD_USBOTG_PWR__USB_TOP_USBOTG_PWR,
MX35_PAD_USBOTG_OC__USB_TOP_USBOTG_OC,
+ /* USBH1 */
+ MX35_PAD_I2C2_CLK__USB_TOP_USBH2_PWR,
+ MX35_PAD_I2C2_DAT__USB_TOP_USBH2_OC,
};
/* OTG config */
@@ -113,6 +117,13 @@
.phy_mode = FSL_USB2_PHY_UTMI_WIDE,
};
+/* USB HOST config */
+static struct mxc_usbh_platform_data usb_host_pdata = {
+ .portsc = MXC_EHCI_MODE_SERIAL,
+ .flags = MXC_EHCI_INTERFACE_SINGLE_UNI |
+ MXC_EHCI_INTERNAL_PHY,
+};
+
/*
* Board specific initialization.
*/
@@ -126,6 +137,8 @@
mxc_register_device(&mxc_otg_udc_device, &usb_otg_pdata);
+ mxc_register_device(&mxc_usbh1, &usb_host_pdata);
+
imx35_add_mxc_nand(&mx35pdk_nand_board_info);
}