ieee1394: sbp2: better handling of transport errors
If the target signals a transport failure via status block, complete the
request with DID_BUSY to indicate to the SCSI subsystem that the command
may succeed when retried.
Also log diagnostic information if the status block shows a transport
related problem. It may point to hardware faults.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>
diff --git a/drivers/ieee1394/sbp2.c b/drivers/ieee1394/sbp2.c
index 5440cd0..6b3350f 100644
--- a/drivers/ieee1394/sbp2.c
+++ b/drivers/ieee1394/sbp2.c
@@ -2213,28 +2213,34 @@
spin_unlock_irqrestore(&scsi_id->sbp2_command_orb_lock, flags);
if (SCpnt) {
- if (STATUS_TEST_RS(sb->ORB_offset_hi_misc))
+ u32 h = sb->ORB_offset_hi_misc;
+ u32 r = STATUS_GET_RESP(h);
+
+ if (r != RESP_STATUS_REQUEST_COMPLETE) {
+ SBP2_WARN("resp 0x%x, sbp_status 0x%x",
+ r, STATUS_GET_SBP_STATUS(h));
scsi_status =
+ r == RESP_STATUS_TRANSPORT_FAILURE ?
+ SBP2_SCSI_STATUS_BUSY :
SBP2_SCSI_STATUS_COMMAND_TERMINATED;
+ }
/*
* See if the target stored any scsi status information.
*/
- if (STATUS_GET_LEN(sb->ORB_offset_hi_misc) > 1) {
+ if (STATUS_GET_LEN(h) > 1) {
SBP2_DEBUG("CHECK CONDITION");
scsi_status = sbp2_status_to_sense_data(
(unchar *)sb, SCpnt->sense_buffer);
}
-
/*
* Check to see if the dead bit is set. If so, we'll
* have to initiate a fetch agent reset.
*/
- if (STATUS_TEST_D(sb->ORB_offset_hi_misc)) {
+ if (STATUS_TEST_DEAD(h)) {
SBP2_DEBUG("Dead bit set - "
"initiating fetch agent reset");
sbp2_agent_reset(scsi_id, 0);
}
-
SBP2_ORB_DEBUG("completing command orb %p", &command->command_orb);
}