ARM: OMAP: Apollon MMC support
Apollon board MMC supports on OMAP2
TODO:
We have to check MMC on H4
Signed-off-by: Kyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap2/board-apollon.c b/arch/arm/mach-omap2/board-apollon.c
index 7993b7b..2db6b73 100644
--- a/arch/arm/mach-omap2/board-apollon.c
+++ b/arch/arm/mach-omap2/board-apollon.c
@@ -166,8 +166,8 @@
static struct omap_mmc_config apollon_mmc_config __initdata = {
.mmc [0] = {
- .enabled = 0,
- .wire4 = 0,
+ .enabled = 1,
+ .wire4 = 1,
.wp_pin = -1,
.power_pin = -1,
.switch_pin = -1,
@@ -257,6 +257,9 @@
/* REVISIT: where's the correct place */
omap_cfg_reg(W19_24XX_SYS_NIRQ);
+ /* Use Interal loop-back in MMC/SDIO Module Input Clock selection */
+ CONTROL_DEVCONF |= (1 << 24);
+
/*
* Make sure the serial ports are muxed on at this point.
* You have to mux them off in device drivers later on