Input: ads7846 - change name of wakeup property to "wakeup-source"
Wakeup property of device is not Linux-specific, it describes intended
system behavior regardless of the OS being used. Therefore let's drop
"linux," prefix, and, while at it, use the same name as I2C bus does:
"wakeup-source".
We keep parsing old name to keep compatibility with old DTSes.
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
diff --git a/Documentation/devicetree/bindings/input/ads7846.txt b/Documentation/devicetree/bindings/input/ads7846.txt
index 5f7619c..df8b127 100644
--- a/Documentation/devicetree/bindings/input/ads7846.txt
+++ b/Documentation/devicetree/bindings/input/ads7846.txt
@@ -64,7 +64,7 @@
pendown-gpio (u32).
pendown-gpio GPIO handle describing the pin the !PENIRQ
line is connected to.
- linux,wakeup use any event on touchscreen as wakeup event.
+ wakeup-source use any event on touchscreen as wakeup event.
Example for a TSC2046 chip connected to an McSPI controller of an OMAP SoC::
diff --git a/drivers/input/touchscreen/ads7846.c b/drivers/input/touchscreen/ads7846.c
index e4eb8a6..0f5f968 100644
--- a/drivers/input/touchscreen/ads7846.c
+++ b/drivers/input/touchscreen/ads7846.c
@@ -1234,7 +1234,8 @@
of_property_read_u32(node, "ti,pendown-gpio-debounce",
&pdata->gpio_pendown_debounce);
- pdata->wakeup = of_property_read_bool(node, "linux,wakeup");
+ pdata->wakeup = of_property_read_bool(node, "wakeup-source") ||
+ of_property_read_bool(node, "linux,wakeup");
pdata->gpio_pendown = of_get_named_gpio(dev->of_node, "pendown-gpio", 0);