e100: convert to net_device_ops
Convert to new network device ops interface. Compile tested only.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/e100.c b/drivers/net/e100.c
index c9c7079..5894716 100644
--- a/drivers/net/e100.c
+++ b/drivers/net/e100.c
@@ -2612,6 +2612,20 @@
return 0;
}
+static const struct net_device_ops e100_netdev_ops = {
+ .ndo_open = e100_open,
+ .ndo_stop = e100_close,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_multicast_list = e100_set_multicast_list,
+ .ndo_set_mac_address = e100_set_mac_address,
+ .ndo_change_mtu = e100_change_mtu,
+ .ndo_do_ioctl = e100_do_ioctl,
+ .ndo_tx_timeout = e100_tx_timeout,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = e100_netpoll,
+#endif
+};
+
static int __devinit e100_probe(struct pci_dev *pdev,
const struct pci_device_id *ent)
{
@@ -2625,19 +2639,10 @@
return -ENOMEM;
}
- netdev->open = e100_open;
- netdev->stop = e100_close;
+ netdev->netdev_ops = &e100_netdev_ops;
netdev->hard_start_xmit = e100_xmit_frame;
- netdev->set_multicast_list = e100_set_multicast_list;
- netdev->set_mac_address = e100_set_mac_address;
- netdev->change_mtu = e100_change_mtu;
- netdev->do_ioctl = e100_do_ioctl;
SET_ETHTOOL_OPS(netdev, &e100_ethtool_ops);
- netdev->tx_timeout = e100_tx_timeout;
netdev->watchdog_timeo = E100_WATCHDOG_PERIOD;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- netdev->poll_controller = e100_netpoll;
-#endif
strncpy(netdev->name, pci_name(pdev), sizeof(netdev->name) - 1);
nic = netdev_priv(netdev);
@@ -2845,7 +2850,7 @@
struct nic *nic = netdev_priv(netdev);
/* Similar to calling e100_down(), but avoids adapter I/O. */
- netdev->stop(netdev);
+ e100_close(netdev);
/* Detach; put netif into a state similar to hotplug unplug. */
napi_enable(&nic->napi);