Merge tag 'renesas-boards-for-v3.14' of git://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas into next/boards

From Simon Horman:
Renesas ARM based SoC board updates for v3.14

* Global
  - Kconfig: Mention Renesas ARM SoCs instead of SH-Mobile

* r7s72100 SoC (RZ/A1H) based Genmai Board
  - Add Multiplatform support
  - Add Reference DT

* r8a7791 (R-Car M2) based Koelsch board
  - Add pinctrl_register_mappings() for Koelsch
  - Hook up SW30-SW36 on Koelsch
  - Mark GPIO keys as wake-up sources
  - Use ->init_late()
  - Add Multiplatform support
  - Set .debounce_interval for GPIO keys
  - Add SW2 to GPIO keys
  - Add Led 6, 7 and 8 support
  - Add reference DT
  - Enable PFC/GPIO

* r8a7790 (R-Car H2) based Lager board
  - Add gpio/fixed regulator for SDHI
  - Add SPI FLASH support on QSPI
  - Mark GPIO keys as wake-up sources
  - Use ->init_late()
  - Set .debounce_interval for GPIO keys

* r8a7778 (R-Car M1) based Bock-W board
  - bockw: remove unused RSND_SSI_CLK_FROM_ADG
  - Set .debounce_interval for GPIO keys
  - Correct FPGA ioremap area
  - Use regulator for MMCIF

* r8a7740 (R-Mobile A1) based Armadillo board
  - Correct FSI address size

* sh7374 (SH-Mobile AP4) based Mackerel board
  - Use pinconf API to configure pin pull-down
  - clk_round_rate() can return a zero to indicate an error

* tag 'renesas-boards-for-v3.14' of git://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas: (75 commits)
  ARM: shmobile: lager: add gpio/fixed regulator for SDHI
  ARM: shmobile: bockw: remove unused RSND_SSI_CLK_FROM_ADG
  ARM: shmobile: armadillo: fixup FSI address size
  ARM: Kconfig: Mention Renesas ARM SoCs instead of SH-Mobile
  ARM: shmobile: mackerel: Use pinconf API to configure pin pull-down
  ARM: shmobile: Lager:add SPI FLASH support on QSPI
  ARM: shmobile: mackerel: clk_round_rate() can return a zero to indicate an error
  ARM: shmobile: Add pinctrl_register_mappings() for Koelsch
  ARM: shmobile: Use ->init_late() on Lager
  ARM: shmobile: Hook up SW30-SW36 on Koelsch
  ARM: shmobile: koelsch: mark GPIO keys as wake-up sources
  ARM: shmobile: Use ->init_late() on Koelsch
  ARM: shmobile: lager: mark GPIO keys as wake-up sources
  ARM: shmobile: r7s72100 Genmai Multiplatform
  ARM: shmobile: r7s72100 Genmai DT reference C bits
  ARM: shmobile: r7s72100 Genmai DT reference DTS bits
  ARM: shmobile: Initial r8a7791 and Koelsch multiplatform support
  ARM: shmobile: koelsch: set .debounce_interval
  ARM: shmobile: lager: set .debounce_interval
  ARM: shmobile: bockw: add pin pull-up setting for SDHI
  ...

Signed-off-by: Olof Johansson <olof@lixom.net>