cfg80211: disallow bridging managed/adhoc interfaces
A number of people have tried to add a wireless interface
(in managed mode) to a bridge and then complained that it
doesn't work. It cannot work, however, because in 802.11
networks all packets need to be acknowledged and as such
need to be sent to the right address. Promiscuous doesn't
help here. The wireless address format used for these
links has only space for three addresses, the
* transmitter, which must be equal to the sender (origin)
* receiver (on the wireless medium), which is the AP in
the case of managed mode
* the recipient (destination), which is on the APs local
network segment
In an IBSS, it is similar, but the receiver and recipient
must match and the third address is used as the BSSID.
To avoid such mistakes in the future, disallow adding a
wireless interface to a bridge.
Felix has recently added a four-address mode to the AP
and client side that can be used (after negotiating that
it is possible, which must happen out-of-band by setting
up both sides) for bridging, so allow that case.
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Acked-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/net/bridge/br_if.c b/net/bridge/br_if.c
index a6f74b2..a2cbe61 100644
--- a/net/bridge/br_if.c
+++ b/net/bridge/br_if.c
@@ -390,6 +390,10 @@
if (dev->br_port != NULL)
return -EBUSY;
+ /* No bridging devices that dislike that (e.g. wireless) */
+ if (dev->priv_flags & IFF_DONT_BRIDGE)
+ return -EOPNOTSUPP;
+
p = new_nbp(br, dev);
if (IS_ERR(p))
return PTR_ERR(p);