ARM: OMAP2: Powerdomain: Add base OMAP2/3 powerdomain code
This patch creates an interface to the powerdomain registers in the
PRM/CM modules on OMAP2/3. This interface is intended to be used by
PM code, e.g., pm.c; not by device drivers directly.
Each powerdomain will be defined in later patches as static
structures. Also defined are dependencies between powerdomains,
used for adding and removing PM_WKDEP and CM_SLEEPDEP bits. The
powerdomain structures are linked into a list at boot by
pwrdm_register(), similar to the OMAP clock code.
The patch adds a Kconfig option, CONFIG_OMAP_DEBUG_POWERDOMAIN, which
when enabled will emit verbose debug messages via pr_debug().
Signed-off-by: Paul Walmsley <paul@pwsan.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/plat-omap/Kconfig b/arch/arm/plat-omap/Kconfig
index b917206..e815fa3 100644
--- a/arch/arm/plat-omap/Kconfig
+++ b/arch/arm/plat-omap/Kconfig
@@ -29,6 +29,18 @@
depends on OMAP_DEBUG_DEVICES
default y if LEDS || LEDS_OMAP_DEBUG
+config OMAP_DEBUG_POWERDOMAIN
+ bool "Emit debug messages from powerdomain layer"
+ depends on ARCH_OMAP2 || ARCH_OMAP3
+ default n
+ help
+ Say Y here if you want to compile in powerdomain layer
+ debugging messages for OMAP2/3. These messages can
+ provide more detail as to why some powerdomain calls
+ may be failing, and will also emit a descriptive message
+ for every powerdomain register write. However, the
+ extra detail costs some memory.
+
config OMAP_RESET_CLOCKS
bool "Reset unused clocks during boot"
depends on ARCH_OMAP