powerpc/fsl_rio: apply changes for RIO spec rev 3
- Remove check for parallel PHY
- Set LP-Serial Register Map type
[akpm@linux-foundation.org: fix build]
[alexandre.bounine@idt.com: fix build fix]
Link: http://lkml.kernel.org/r/20160802184932.2755-1-alexandre.bounine@idt.com
Link: http://lkml.kernel.org/r/1469125134-16523-13-git-send-email-alexandre.bounine@idt.com
Signed-off-by: Alexandre Bounine <alexandre.bounine@idt.com>
Cc: Matt Porter <mporter@kernel.crashing.org>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Michael Ellerman <mpe@ellerman.id.au>
Cc: Andre van Herk <andre.van.herk@prodrive-technologies.com>
Cc: Barry Wood <barry.wood@idt.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/arch/powerpc/sysdev/fsl_rio.c b/arch/powerpc/sysdev/fsl_rio.c
index 386790c..984e816 100644
--- a/arch/powerpc/sysdev/fsl_rio.c
+++ b/arch/powerpc/sysdev/fsl_rio.c
@@ -643,19 +643,11 @@
port->ops = ops;
port->priv = priv;
port->phys_efptr = 0x100;
+ port->phys_rmap = 1;
priv->regs_win = rio_regs_win;
- /* Probe the master port phy type */
ccsr = in_be32(priv->regs_win + RIO_CCSR + i*0x20);
- port->phy_type = (ccsr & 1) ? RIO_PHY_SERIAL : RIO_PHY_PARALLEL;
- if (port->phy_type == RIO_PHY_PARALLEL) {
- dev_err(&dev->dev, "RIO: Parallel PHY type, unsupported port type!\n");
- release_resource(&port->iores);
- kfree(priv);
- kfree(port);
- continue;
- }
- dev_info(&dev->dev, "RapidIO PHY type: Serial\n");
+
/* Checking the port training status */
if (in_be32((priv->regs_win + RIO_ESCSR + i*0x20)) & 1) {
dev_err(&dev->dev, "Port %d is not ready. "
@@ -705,11 +697,9 @@
((i == 0) ? RIO_INB_ATMU_REGS_PORT1_OFFSET :
RIO_INB_ATMU_REGS_PORT2_OFFSET));
-
- /* Set to receive any dist ID for serial RapidIO controller. */
- if (port->phy_type == RIO_PHY_SERIAL)
- out_be32((priv->regs_win
- + RIO_ISR_AACR + i*0x80), RIO_ISR_AACR_AA);
+ /* Set to receive packets with any dest ID */
+ out_be32((priv->regs_win + RIO_ISR_AACR + i*0x80),
+ RIO_ISR_AACR_AA);
/* Configure maintenance transaction window */
out_be32(&priv->maint_atmu_regs->rowbar,