Documentation: i2c: describe devicetree method for instantiating devices

Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
diff --git a/Documentation/i2c/instantiating-devices b/Documentation/i2c/instantiating-devices
index c70e7a7..6df095a 100644
--- a/Documentation/i2c/instantiating-devices
+++ b/Documentation/i2c/instantiating-devices
@@ -8,8 +8,8 @@
 several ways to achieve this, depending on the context and requirements.
 
 
-Method 1: Declare the I2C devices by bus number
------------------------------------------------
+Method 1a: Declare the I2C devices by bus number
+------------------------------------------------
 
 This method is appropriate when the I2C bus is a system bus as is the case
 for many embedded systems. On such systems, each I2C bus has a number
@@ -51,6 +51,36 @@
 they sit on goes away (if ever.)
 
 
+Method 1b: Declare the I2C devices via devicetree
+-------------------------------------------------
+
+This method has the same implications as method 1a. The declaration of I2C
+devices is here done via devicetree as subnodes of the master controller.
+
+Example:
+
+	i2c1: i2c@400a0000 {
+		/* ... master properties skipped ... */
+		clock-frequency = <100000>;
+
+		flash@50 {
+			compatible = "atmel,24c256";
+			reg = <0x50>;
+		};
+
+		pca9532: gpio@60 {
+			compatible = "nxp,pca9532";
+			gpio-controller;
+			#gpio-cells = <2>;
+			reg = <0x60>;
+		};
+	};
+
+Here, two devices are attached to the bus using a speed of 100kHz. For
+additional properties which might be needed to set up the device, please refer
+to its devicetree documentation in Documentation/devicetree/bindings/.
+
+
 Method 2: Instantiate the devices explicitly
 --------------------------------------------