ifx6x60: SPI protocol driver for Infineon 6x60 modem
Prototype driver for the IFX6x60 series of SPI attached modems by Jim
Stanley and Russ Gorby
Signed-off-by: Russ Gorby <richardx.r.gorby@intel.com>
[Some reworking and a major cleanup]
Signed-off-by: Alan Cox <alan@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/serial/ifx6x60.h b/drivers/serial/ifx6x60.h
new file mode 100644
index 0000000..deb7b8d
--- /dev/null
+++ b/drivers/serial/ifx6x60.h
@@ -0,0 +1,129 @@
+/****************************************************************************
+ *
+ * Driver for the IFX spi modem.
+ *
+ * Copyright (C) 2009, 2010 Intel Corp
+ * Jim Stanley <jim.stanley@intel.com>
+ *
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
+ * GNU General Public License for more details.
+ *
+ * You should have received a copy of the GNU General Public License
+ * along with this program; if not, write to the Free Software
+ * Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301,
+ * USA
+ *
+ *
+ *
+ *****************************************************************************/
+#ifndef _IFX6X60_H
+#define _IFX6X60_H
+
+#define DRVNAME "ifx6x60"
+#define TTYNAME "ttyIFX"
+
+/* #define IFX_THROTTLE_CODE */
+
+#define IFX_SPI_MAX_MINORS 1
+#define IFX_SPI_TRANSFER_SIZE 2048
+#define IFX_SPI_FIFO_SIZE 4096
+
+#define IFX_SPI_HEADER_OVERHEAD 4
+#define IFX_RESET_TIMEOUT msecs_to_jiffies(50)
+
+/* device flags bitfield definitions */
+#define IFX_SPI_STATE_PRESENT 0
+#define IFX_SPI_STATE_IO_IN_PROGRESS 1
+#define IFX_SPI_STATE_IO_READY 2
+#define IFX_SPI_STATE_TIMER_PENDING 3
+
+/* flow control bitfields */
+#define IFX_SPI_DCD 0
+#define IFX_SPI_CTS 1
+#define IFX_SPI_DSR 2
+#define IFX_SPI_RI 3
+#define IFX_SPI_DTR 4
+#define IFX_SPI_RTS 5
+#define IFX_SPI_TX_FC 6
+#define IFX_SPI_RX_FC 7
+#define IFX_SPI_UPDATE 8
+
+#define IFX_SPI_PAYLOAD_SIZE (IFX_SPI_TRANSFER_SIZE - \
+ IFX_SPI_HEADER_OVERHEAD)
+
+#define IFX_SPI_IRQ_TYPE DETECT_EDGE_RISING
+#define IFX_SPI_GPIO_TARGET 0
+#define IFX_SPI_GPIO0 0x105
+
+#define IFX_SPI_STATUS_TIMEOUT (2000*HZ)
+
+/* values for bits in power status byte */
+#define IFX_SPI_POWER_DATA_PENDING 1
+#define IFX_SPI_POWER_SRDY 2
+
+struct ifx_spi_device {
+ /* Our SPI device */
+ struct spi_device *spi_dev;
+
+ /* Port specific data */
+ struct kfifo tx_fifo;
+ spinlock_t fifo_lock;
+ unsigned long signal_state;
+
+ /* TTY Layer logic */
+ struct tty_port tty_port;
+ struct device *tty_dev;
+ int minor;
+
+ /* Low level I/O work */
+ struct tasklet_struct io_work_tasklet;
+ unsigned long flags;
+ dma_addr_t rx_dma;
+ dma_addr_t tx_dma;
+
+ int is_6160; /* Modem type */
+
+ spinlock_t write_lock;
+ int write_pending;
+ spinlock_t power_lock;
+ unsigned char power_status;
+
+ unsigned char *rx_buffer;
+ unsigned char *tx_buffer;
+ dma_addr_t rx_bus;
+ dma_addr_t tx_bus;
+ unsigned char spi_more;
+ unsigned char spi_slave_cts;
+
+ struct timer_list spi_timer;
+
+ struct spi_message spi_msg;
+ struct spi_transfer spi_xfer;
+
+ struct {
+ /* gpio lines */
+ unsigned short srdy; /* slave-ready gpio */
+ unsigned short mrdy; /* master-ready gpio */
+ unsigned short reset; /* modem-reset gpio */
+ unsigned short po; /* modem-on gpio */
+ unsigned short reset_out; /* modem-in-reset gpio */
+ /* state/stats */
+ int unack_srdy_int_nb;
+ } gpio;
+
+ /* modem reset */
+ unsigned long mdm_reset_state;
+#define MR_START 0
+#define MR_INPROGRESS 1
+#define MR_COMPLETE 2
+ wait_queue_head_t mdm_reset_wait;
+};
+
+#endif /* _IFX6X60_H */