[PATCH] sky2: remove pci-express hacks
Eliminate special case tuning for PCI-Express. This code
causes receive hangs and doesn't help performance much anyway.
Signed-off-by: Stephen Hemminger <shemmnger@osdl.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c
index 52c7b18..c6c3275 100644
--- a/drivers/net/sky2.c
+++ b/drivers/net/sky2.c
@@ -651,12 +651,12 @@
}
/* Setup Bus Memory Interface */
-static void sky2_qset(struct sky2_hw *hw, u16 q, u32 wm)
+static void sky2_qset(struct sky2_hw *hw, u16 q)
{
sky2_write32(hw, Q_ADDR(q, Q_CSR), BMU_CLR_RESET);
sky2_write32(hw, Q_ADDR(q, Q_CSR), BMU_OPER_INIT);
sky2_write32(hw, Q_ADDR(q, Q_CSR), BMU_FIFO_OP_ON);
- sky2_write32(hw, Q_ADDR(q, Q_WM), wm);
+ sky2_write32(hw, Q_ADDR(q, Q_WM), BMU_WM_DEFAULT);
}
/* Setup prefetch unit registers. This is the interface between
@@ -921,7 +921,7 @@
int i;
sky2->rx_put = sky2->rx_next = 0;
- sky2_qset(hw, rxq, is_pciex(hw) ? 0x80 : 0x600);
+ sky2_qset(hw, rxq);
sky2_prefetch_init(hw, rxq, sky2->rx_le_map, RX_LE_SIZE - 1);
rx_set_checksum(sky2);
@@ -1004,7 +1004,7 @@
sky2_write8(hw, RB_ADDR(port == 0 ? Q_XS1 : Q_XS2, RB_CTRL),
RB_RST_SET);
- sky2_qset(hw, txqaddr[port], 0x600);
+ sky2_qset(hw, txqaddr[port]);
if (hw->chip_id == CHIP_ID_YUKON_EC_U)
sky2_write16(hw, Q_ADDR(txqaddr[port], Q_AL), 0x1a0);
@@ -2148,20 +2148,6 @@
sky2_write8(hw, RAM_BUFFER(i, B3_RI_RTO_XS2), SK_RI_TO_53);
}
- if (is_pciex(hw)) {
- u16 pctrl;
-
- /* change Max. Read Request Size to 2048 bytes */
- pci_read_config_word(hw->pdev, PEX_DEV_CTRL, &pctrl);
- pctrl &= ~PEX_DC_MAX_RRS_MSK;
- pctrl |= PEX_DC_MAX_RD_RQ_SIZE(4);
-
-
- sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_ON);
- pci_write_config_word(hw->pdev, PEX_DEV_CTRL, pctrl);
- sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF);
- }
-
sky2_write32(hw, B0_HWE_IMSK, Y2_HWE_ALL_MASK);
spin_lock_bh(&hw->phy_lock);