wlcore: re-enable idle handling
We need some stuff done on idle change, most notably we have to stop
sched-scanning. Take care of this by reintroducing idle handling.
Signed-off-by: Arik Nemtsov <arik@wizery.com>
Signed-off-by: Eliad Peller <eliad@wizery.com>
Signed-off-by: Luciano Coelho <luciano.coelho@intel.com>
diff --git a/drivers/net/wireless/ti/wlcore/main.c b/drivers/net/wireless/ti/wlcore/main.c
index 7a1a435..131e60f 100644
--- a/drivers/net/wireless/ti/wlcore/main.c
+++ b/drivers/net/wireless/ti/wlcore/main.c
@@ -2927,6 +2927,25 @@
wlvif->rate_set = wlvif->basic_rate_set;
}
+static void wl1271_sta_handle_idle(struct wl1271 *wl, struct wl12xx_vif *wlvif,
+ bool idle)
+{
+ bool cur_idle = !test_bit(WLVIF_FLAG_ACTIVE, &wlvif->flags);
+
+ if (idle == cur_idle)
+ return;
+
+ if (idle) {
+ clear_bit(WLVIF_FLAG_ACTIVE, &wlvif->flags);
+ } else {
+ /* The current firmware only supports sched_scan in idle */
+ if (wl->sched_vif == wlvif)
+ wl->ops->sched_scan_stop(wl, wlvif);
+
+ set_bit(WLVIF_FLAG_ACTIVE, &wlvif->flags);
+ }
+}
+
static int wl12xx_config_vif(struct wl1271 *wl, struct wl12xx_vif *wlvif,
struct ieee80211_conf *conf, u32 changed)
{
@@ -4179,6 +4198,9 @@
do_join = true;
}
+ if (changed & BSS_CHANGED_IDLE && !is_ibss)
+ wl1271_sta_handle_idle(wl, wlvif, bss_conf->idle);
+
if (changed & BSS_CHANGED_CQM) {
bool enable = false;
if (bss_conf->cqm_rssi_thold)
diff --git a/drivers/net/wireless/ti/wlcore/wlcore_i.h b/drivers/net/wireless/ti/wlcore/wlcore_i.h
index 3f4f08b..2a50e08 100644
--- a/drivers/net/wireless/ti/wlcore/wlcore_i.h
+++ b/drivers/net/wireless/ti/wlcore/wlcore_i.h
@@ -255,6 +255,7 @@
WLVIF_FLAG_CS_PROGRESS,
WLVIF_FLAG_AP_PROBE_RESP_SET,
WLVIF_FLAG_IN_USE,
+ WLVIF_FLAG_ACTIVE,
};
struct wl12xx_vif;