netdev: seeq8005 convert to net_device_ops
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/seeq8005.c b/drivers/net/seeq8005.c
index 12a8fff..ebbbe09 100644
--- a/drivers/net/seeq8005.c
+++ b/drivers/net/seeq8005.c
@@ -143,6 +143,17 @@
return ERR_PTR(err);
}
+static const struct net_device_ops seeq8005_netdev_ops = {
+ .ndo_open = seeq8005_open,
+ .ndo_stop = seeq8005_close,
+ .ndo_start_xmit = seeq8005_send_packet,
+ .ndo_tx_timeout = seeq8005_timeout,
+ .ndo_set_multicast_list = set_multicast_list,
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_validate_addr = eth_validate_addr,
+};
+
/* This is the real probe routine. Linux has a history of friendly device
probes on the ISA bus. A good device probes avoids doing writes, and
verifies that the correct device exists and functions. */
@@ -332,12 +343,8 @@
}
}
#endif
- dev->open = seeq8005_open;
- dev->stop = seeq8005_close;
- dev->hard_start_xmit = seeq8005_send_packet;
- dev->tx_timeout = seeq8005_timeout;
+ dev->netdev_ops = &seeq8005_netdev_ops;
dev->watchdog_timeo = HZ/20;
- dev->set_multicast_list = set_multicast_list;
dev->flags &= ~IFF_MULTICAST;
return 0;