cfg80211: connect/disconnect API
This patch introduces the cfg80211 connect/disconnect API.
The goal here is to run the AUTH and ASSOC steps in one call.
This is needed for some fullmac cards that run both steps
directly from the target, after the host driver sends a
connect command.
Additionally, all the new crypto parameters for connect()
are now also valid for associate() -- although associate
requires the IEs to be used, the information can be useful
for drivers and should be given.
Signed-off-by: Samuel Ortiz <samuel.ortiz@intel.com>
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/net/wireless/core.c b/net/wireless/core.c
index d41b741..314e00f 100644
--- a/net/wireless/core.c
+++ b/net/wireless/core.c
@@ -546,6 +546,7 @@
"symlink to netdev!\n");
}
wdev->netdev = dev;
+ wdev->sme_state = CFG80211_SME_IDLE;
#ifdef CONFIG_WIRELESS_EXT
wdev->wext.default_key = -1;
wdev->wext.default_mgmt_key = -1;
@@ -553,11 +554,20 @@
mutex_unlock(&rdev->devlist_mtx);
break;
case NETDEV_GOING_DOWN:
- if (wdev->iftype != NL80211_IFTYPE_ADHOC)
- break;
if (!wdev->ssid_len)
break;
- cfg80211_leave_ibss(rdev, dev, true);
+
+ switch (wdev->iftype) {
+ case NL80211_IFTYPE_ADHOC:
+ cfg80211_leave_ibss(rdev, dev, true);
+ break;
+ case NL80211_IFTYPE_STATION:
+ cfg80211_disconnect(rdev, dev,
+ WLAN_REASON_DEAUTH_LEAVING);
+ break;
+ default:
+ break;
+ }
break;
case NETDEV_UP:
#ifdef CONFIG_WIRELESS_EXT