via-rhine: changed to use netdev_alloc_skb() from dev_alloc_skb
Use netdev_alloc_skb. This sets skb->dev and allows
arch specific allocation. Also cleanup the alignment code.
Signed-off-by: Kevin Lo <kevlo@kevlo.org>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
diff --git a/drivers/net/via-rhine.c b/drivers/net/via-rhine.c
index 96dff04..5b78700 100644
--- a/drivers/net/via-rhine.c
+++ b/drivers/net/via-rhine.c
@@ -914,7 +914,7 @@
/* Fill in the Rx buffers. Handle allocation failure gracefully. */
for (i = 0; i < RX_RING_SIZE; i++) {
- struct sk_buff *skb = dev_alloc_skb(rp->rx_buf_sz);
+ struct sk_buff *skb = netdev_alloc_skb(dev, rp->rx_buf_sz);
rp->rx_skbuff[i] = skb;
if (skb == NULL)
break;
@@ -1473,8 +1473,8 @@
/* Check if the packet is long enough to accept without
copying to a minimally-sized skbuff. */
if (pkt_len < rx_copybreak &&
- (skb = dev_alloc_skb(pkt_len + 2)) != NULL) {
- skb_reserve(skb, 2); /* 16 byte align the IP header */
+ (skb = netdev_alloc_skb(dev, pkt_len + NET_IP_ALIGN)) != NULL) {
+ skb_reserve(skb, NET_IP_ALIGN); /* 16 byte align the IP header */
pci_dma_sync_single_for_cpu(rp->pdev,
rp->rx_skbuff_dma[entry],
rp->rx_buf_sz,
@@ -1518,7 +1518,7 @@
struct sk_buff *skb;
entry = rp->dirty_rx % RX_RING_SIZE;
if (rp->rx_skbuff[entry] == NULL) {
- skb = dev_alloc_skb(rp->rx_buf_sz);
+ skb = netdev_alloc_skb(dev, rp->rx_buf_sz);
rp->rx_skbuff[entry] = skb;
if (skb == NULL)
break; /* Better luck next round. */