dsa/mv88e6131: fix unknown multicast/broadcast forwarding on mv88e6085
The 88e6085 has a few differences from the other devices in the port
control registers, causing unknown multicast/broadcast packets to get
dropped when using the standard port setup.
At the same time update kconfig to clarify that the mv88e6085 is now
supported.
Signed-off-by: Peter Korsgaard <jacmet@sunsite.dk>
Acked-by: Lennert Buytenhek <buytenh@wantstofly.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/dsa/mv88e6131.c b/net/dsa/mv88e6131.c
index 3da4188..45f7411 100644
--- a/net/dsa/mv88e6131.c
+++ b/net/dsa/mv88e6131.c
@@ -207,8 +207,15 @@
* mode, but do not enable forwarding of unknown unicasts.
*/
val = 0x0433;
- if (p == dsa_upstream_port(ds))
+ if (p == dsa_upstream_port(ds)) {
val |= 0x0104;
+ /*
+ * On 6085, unknown multicast forward is controlled
+ * here rather than in Port Control 2 register.
+ */
+ if (ps->id == ID_6085)
+ val |= 0x0008;
+ }
if (ds->dsa_port_mask & (1 << p))
val |= 0x0100;
REG_WRITE(addr, 0x04, val);
@@ -251,10 +258,19 @@
* If this is the upstream port for this switch, enable
* forwarding of unknown multicast addresses.
*/
- val = 0x0080 | dsa_upstream_port(ds);
- if (p == dsa_upstream_port(ds))
- val |= 0x0040;
- REG_WRITE(addr, 0x08, val);
+ if (ps->id == ID_6085)
+ /*
+ * on 6085, bits 3:0 are reserved, bit 6 control ARP
+ * mirroring, and multicast forward is handled in
+ * Port Control register.
+ */
+ REG_WRITE(addr, 0x08, 0x0080);
+ else {
+ val = 0x0080 | dsa_upstream_port(ds);
+ if (p == dsa_upstream_port(ds))
+ val |= 0x0040;
+ REG_WRITE(addr, 0x08, val);
+ }
/*
* Rate Control: disable ingress rate limiting.