OMAP2/3 board-*.c files: read bootloader configuration earlier
Most board-*.c files read configuration data from the bootloader in
their .init_machine() function. This needs to happen earlier, at some
point before omap2_init_common_hw() is called. This is because a
future patch will use the bootloader serial console port information
to enable the UART clocks earlier, immediately after omap2_clk_init().
This is in turn necessary since otherwise clock tree usecounts on
clocks like dpll4_m2x2_ck will be bogus, which can cause the
currently-active console UART clock to be disabled during boot.
Signed-off-by: Paul Walmsley <paul@pwsan.com>
diff --git a/arch/arm/mach-omap2/io.c b/arch/arm/mach-omap2/io.c
index 4bfe873..470b1d1 100644
--- a/arch/arm/mach-omap2/io.c
+++ b/arch/arm/mach-omap2/io.c
@@ -32,6 +32,7 @@
#include <mach/sram.h>
#include <mach/sdrc.h>
#include <mach/gpmc.h>
+#include <mach/serial.h>
#ifndef CONFIG_ARCH_OMAP4 /* FIXME: Remove this once clkdev is ready */
#include "clock.h"
@@ -287,6 +288,7 @@
pwrdm_init(powerdomains_omap);
clkdm_init(clockdomains_omap, clkdm_pwrdm_autodeps);
omap2_clk_init();
+ omap_serial_early_init();
omap_pm_if_init();
omap2_sdrc_init(sdrc_cs0, sdrc_cs1);
_omap2_init_reprogram_sdrc();