ixgbe: use BIT() macro
Several areas of ixgbe were written before widespread usage of the
BIT(n) macro. With the impending release of GCC 6 and its associated new
warnings, some usages such as (1 << 31) have been noted within the ixgbe
driver source. Fix these wholesale and prevent future issues by simply
using BIT macro instead of hand coded bit shifts.
Also fix a few shifts that are shifting values into place by using the
'u' prefix to indicate unsigned. It doesn't strictly matter in these
cases because we're not shifting by too large a value, but these are all
unsigned values and should be indicated as such.
Signed-off-by: Jacob Keller <jacob.e.keller@intel.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_ethtool.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_ethtool.c
index 9f76be1..d3efcb4 100644
--- a/drivers/net/ethernet/intel/ixgbe/ixgbe_ethtool.c
+++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_ethtool.c
@@ -1586,7 +1586,7 @@
/* Test each interrupt */
for (; i < 10; i++) {
/* Interrupt to test */
- mask = 1 << i;
+ mask = BIT(i);
if (!shared_int) {
/*
@@ -3014,14 +3014,14 @@
info->phc_index = -1;
info->tx_types =
- (1 << HWTSTAMP_TX_OFF) |
- (1 << HWTSTAMP_TX_ON);
+ BIT(HWTSTAMP_TX_OFF) |
+ BIT(HWTSTAMP_TX_ON);
info->rx_filters =
- (1 << HWTSTAMP_FILTER_NONE) |
- (1 << HWTSTAMP_FILTER_PTP_V1_L4_SYNC) |
- (1 << HWTSTAMP_FILTER_PTP_V1_L4_DELAY_REQ) |
- (1 << HWTSTAMP_FILTER_PTP_V2_EVENT);
+ BIT(HWTSTAMP_FILTER_NONE) |
+ BIT(HWTSTAMP_FILTER_PTP_V1_L4_SYNC) |
+ BIT(HWTSTAMP_FILTER_PTP_V1_L4_DELAY_REQ) |
+ BIT(HWTSTAMP_FILTER_PTP_V2_EVENT);
break;
default:
return ethtool_op_get_ts_info(dev, info);