SM501: initialise SDRAM clock before bus clocks
This init sequence of setting the SDRAM clock before the bus clock is
recommend by Silicon Motion to stop problems with writes not sticking into
registers.
Signed-off-by: Vincent Sanders <vince@simtec.co.uk>
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/mfd/sm501.c b/drivers/mfd/sm501.c
index 72bbecf..4c4412e 100644
--- a/drivers/mfd/sm501.c
+++ b/drivers/mfd/sm501.c
@@ -843,15 +843,15 @@
sm501_init_reg(sm, SM501_GPIO31_0_CONTROL, &init->gpio_low);
sm501_init_reg(sm, SM501_GPIO63_32_CONTROL, &init->gpio_high);
- if (init->mclk) {
- dev_info(sm->dev, "setting MCLK to %ld\n", init->mclk);
- sm501_set_clock(sm->dev, SM501_CLOCK_MCLK, init->mclk);
- }
-
if (init->m1xclk) {
dev_info(sm->dev, "setting M1XCLK to %ld\n", init->m1xclk);
sm501_set_clock(sm->dev, SM501_CLOCK_M1XCLK, init->m1xclk);
}
+
+ if (init->mclk) {
+ dev_info(sm->dev, "setting MCLK to %ld\n", init->mclk);
+ sm501_set_clock(sm->dev, SM501_CLOCK_MCLK, init->mclk);
+ }
}
static unsigned int sm501_mem_local[] = {