| * MSM Serial UART for GENI based cores. |
| |
| The MSM serial UART driver supports low speed and high speed use-cases. |
| This is meant only for QUPv3 GENI based cores and isn't backwards compatible. |
| There is support for console usecases and for higher speed usecases that need |
| DMA. |
| |
| Required properties: |
| - compatible: should contain "qcom,msm-geni-uart, qcom,msm-geni-console" |
| for UART console usecases, "qcom,msm-geni-uart, qcom,msm-geni-serial-hs" |
| for High Speed (HS) usecases. |
| - reg: Should contain UART register location and length. |
| - interrupts: Should contain UART core interrupts. |
| - clocks: clocks needed for UART, includes the core and AHB clock. |
| - pinctrl-names/pinctrl-0/1: The GPIOs assigned to this core. The names |
| Should be "active" and "sleep" for the pin confuguration when core is active |
| or when entering sleep state. |
| |
| Example: |
| qupv3_uart11: qcom,qup_uart@0xa88000 { |
| compatible = "qcom,msm-geni-uart"; |
| reg = <0xa88000 0x7000>; |
| reg-names = "se_phys"; |
| clock-names = "se-clk", "m-ahb", "s-ahb"; |
| clocks = <&clock_gcc GCC_QUPV3_WRAP0_S0_CLK>, |
| <&clock_gcc GCC_QUPV3_WRAP_0_M_AHB_CLK>, |
| <&clock_gcc GCC_QUPV3_WRAP_0_S_AHB_CLK>; |
| pinctrl-names = "default", "sleep"; |
| pinctrl-0 = <&qup_1_uart_3_active>; |
| pinctrl-1 = <&qup_1_uart_3_sleep>; |
| interrupts = <0 355 0>; |
| }; |