sky2: EC-U performance and jumbo support
The Yukon EC Ultra chips have transmit settings for store and
forward and PCI buffering. By setting these appropriately, normal
performance goes from 750Mbytes/sec to 940Mbytes/sec (non-jumbo).
It is also possible to do Jumbo mode, but it means turning off
TSO and checksum offload so the performance gets worse. There isn't
enough buffering for checksum offload to work.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c
index 910c600..4d1ec78 100644
--- a/drivers/net/sky2.c
+++ b/drivers/net/sky2.c
@@ -743,12 +743,17 @@
if (hw->chip_id == CHIP_ID_YUKON_EC_U || hw->chip_id == CHIP_ID_YUKON_EX) {
sky2_write8(hw, SK_REG(port, RX_GMF_LP_THR), 768/8);
sky2_write8(hw, SK_REG(port, RX_GMF_UP_THR), 1024/8);
- if (hw->dev[port]->mtu > ETH_DATA_LEN) {
- /* set Tx GMAC FIFO Almost Empty Threshold */
- sky2_write32(hw, SK_REG(port, TX_GMF_AE_THR), 0x180);
- /* Disable Store & Forward mode for TX */
- sky2_write32(hw, SK_REG(port, TX_GMF_CTRL_T), TX_STFW_DIS);
- }
+
+ /* set Tx GMAC FIFO Almost Empty Threshold */
+ sky2_write32(hw, SK_REG(port, TX_GMF_AE_THR),
+ (ECU_JUMBO_WM << 16) | ECU_AE_THR);
+
+ if (hw->dev[port]->mtu > ETH_DATA_LEN)
+ sky2_write32(hw, SK_REG(port, TX_GMF_CTRL_T),
+ TX_JUMBO_ENA | TX_STFW_DIS);
+ else
+ sky2_write32(hw, SK_REG(port, TX_GMF_CTRL_T),
+ TX_JUMBO_DIS | TX_STFW_ENA);
}
}
@@ -1281,7 +1286,7 @@
/* Set almost empty threshold */
if (hw->chip_id == CHIP_ID_YUKON_EC_U
&& hw->chip_rev == CHIP_REV_YU_EC_U_A0)
- sky2_write16(hw, Q_ADDR(txqaddr[port], Q_AL), 0x1a0);
+ sky2_write16(hw, Q_ADDR(txqaddr[port], Q_AL), ECU_TXFF_LEV);
sky2_prefetch_init(hw, txqaddr[port], sky2->tx_le_map,
TX_RING_SIZE - 1);
@@ -1587,13 +1592,6 @@
sky2_write32(hw, RB_ADDR(txqaddr[port], RB_CTRL),
RB_RST_SET | RB_DIS_OP_MD);
- /* WA for dev. #4.209 */
- if (hw->chip_id == CHIP_ID_YUKON_EC_U
- && (hw->chip_rev == CHIP_REV_YU_EC_U_A1 || hw->chip_rev == CHIP_REV_YU_EC_U_B0))
- sky2_write32(hw, SK_REG(port, TX_GMF_CTRL_T),
- sky2->speed != SPEED_1000 ?
- TX_STFW_ENA : TX_STFW_DIS);
-
ctrl = gma_read16(hw, port, GM_GP_CTRL);
ctrl &= ~(GM_GPCR_TX_ENA | GM_GPCR_RX_ENA);
gma_write16(hw, port, GM_GP_CTRL, ctrl);
@@ -1893,6 +1891,7 @@
{
struct sky2_port *sky2 = netdev_priv(dev);
struct sky2_hw *hw = sky2->hw;
+ unsigned port = sky2->port;
int err;
u16 ctl, mode;
u32 imask;
@@ -1900,10 +1899,6 @@
if (new_mtu < ETH_ZLEN || new_mtu > ETH_JUMBO_MTU)
return -EINVAL;
- /* TSO on Yukon Ultra and MTU > 1500 not supported */
- if (hw->chip_id == CHIP_ID_YUKON_EC_U && new_mtu > ETH_DATA_LEN)
- dev->features &= ~NETIF_F_TSO;
-
if (!netif_running(dev)) {
dev->mtu = new_mtu;
return 0;
@@ -1918,8 +1913,18 @@
synchronize_irq(hw->pdev->irq);
- ctl = gma_read16(hw, sky2->port, GM_GP_CTRL);
- gma_write16(hw, sky2->port, GM_GP_CTRL, ctl & ~GM_GPCR_RX_ENA);
+ if (hw->chip_id == CHIP_ID_YUKON_EC_U || hw->chip_id == CHIP_ID_YUKON_EX) {
+ if (new_mtu > ETH_DATA_LEN) {
+ sky2_write32(hw, SK_REG(port, TX_GMF_CTRL_T),
+ TX_JUMBO_ENA | TX_STFW_DIS);
+ dev->features &= NETIF_F_TSO | NETIF_F_SG | NETIF_F_IP_CSUM;
+ } else
+ sky2_write32(hw, SK_REG(port, TX_GMF_CTRL_T),
+ TX_JUMBO_DIS | TX_STFW_ENA);
+ }
+
+ ctl = gma_read16(hw, port, GM_GP_CTRL);
+ gma_write16(hw, port, GM_GP_CTRL, ctl & ~GM_GPCR_RX_ENA);
sky2_rx_stop(sky2);
sky2_rx_clean(sky2);
@@ -1931,9 +1936,9 @@
if (dev->mtu > ETH_DATA_LEN)
mode |= GM_SMOD_JUMBO_ENA;
- gma_write16(hw, sky2->port, GM_SERIAL_MODE, mode);
+ gma_write16(hw, port, GM_SERIAL_MODE, mode);
- sky2_write8(hw, RB_ADDR(rxqaddr[sky2->port], RB_CTRL), RB_ENA_OP_MD);
+ sky2_write8(hw, RB_ADDR(rxqaddr[port], RB_CTRL), RB_ENA_OP_MD);
err = sky2_rx_start(sky2);
sky2_write32(hw, B0_IMSK, imask);
@@ -1941,7 +1946,7 @@
if (err)
dev_close(dev);
else {
- gma_write16(hw, sky2->port, GM_GP_CTRL, ctl);
+ gma_write16(hw, port, GM_GP_CTRL, ctl);
netif_poll_enable(hw->dev[0]);
netif_wake_queue(dev);
@@ -3334,6 +3339,36 @@
regs->len - B3_RI_WTO_R1);
}
+/* In order to do Jumbo packets on these chips, need to turn off the
+ * transmit store/forward. Therefore checksum offload won't work.
+ */
+static int no_tx_offload(struct net_device *dev)
+{
+ const struct sky2_port *sky2 = netdev_priv(dev);
+ const struct sky2_hw *hw = sky2->hw;
+
+ return dev->mtu > ETH_DATA_LEN &&
+ (hw->chip_id == CHIP_ID_YUKON_EX
+ || hw->chip_id == CHIP_ID_YUKON_EC_U);
+}
+
+static int sky2_set_tx_csum(struct net_device *dev, u32 data)
+{
+ if (data && no_tx_offload(dev))
+ return -EINVAL;
+
+ return ethtool_op_set_tx_csum(dev, data);
+}
+
+
+static int sky2_set_tso(struct net_device *dev, u32 data)
+{
+ if (data && no_tx_offload(dev))
+ return -EINVAL;
+
+ return ethtool_op_set_tso(dev, data);
+}
+
static const struct ethtool_ops sky2_ethtool_ops = {
.get_settings = sky2_get_settings,
.set_settings = sky2_set_settings,
@@ -3349,9 +3384,9 @@
.get_sg = ethtool_op_get_sg,
.set_sg = ethtool_op_set_sg,
.get_tx_csum = ethtool_op_get_tx_csum,
- .set_tx_csum = ethtool_op_set_tx_csum,
+ .set_tx_csum = sky2_set_tx_csum,
.get_tso = ethtool_op_get_tso,
- .set_tso = ethtool_op_set_tso,
+ .set_tso = sky2_set_tso,
.get_rx_csum = sky2_get_rx_csum,
.set_rx_csum = sky2_set_rx_csum,
.get_strings = sky2_get_strings,