[PATCH] Cleanup SLHC configuration
Convert selection of serial line header compression to use CONFIG_SLHC
rather than makefile ifeq uglyness. This makes it easier to select
the SLHC module from other code.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/Makefile b/drivers/net/Makefile
index c91e951..038a8e0 100644
--- a/drivers/net/Makefile
+++ b/drivers/net/Makefile
@@ -2,10 +2,6 @@
# Makefile for the Linux network (ethercard) device drivers.
#
-ifeq ($(CONFIG_ISDN_PPP),y)
- obj-$(CONFIG_ISDN) += slhc.o
-endif
-
obj-$(CONFIG_E1000) += e1000/
obj-$(CONFIG_IBM_EMAC) += ibm_emac/
obj-$(CONFIG_IXGB) += ixgb/
@@ -111,7 +107,7 @@
obj-$(CONFIG_MV643XX_ETH) += mv643xx_eth.o
-obj-$(CONFIG_PPP) += ppp_generic.o slhc.o
+obj-$(CONFIG_PPP) += ppp_generic.o
obj-$(CONFIG_PPP_ASYNC) += ppp_async.o
obj-$(CONFIG_PPP_SYNC_TTY) += ppp_synctty.o
obj-$(CONFIG_PPP_DEFLATE) += ppp_deflate.o
@@ -120,9 +116,7 @@
obj-$(CONFIG_PPPOE) += pppox.o pppoe.o
obj-$(CONFIG_SLIP) += slip.o
-ifeq ($(CONFIG_SLIP_COMPRESSED),y)
- obj-$(CONFIG_SLIP) += slhc.o
-endif
+obj-$(CONFIG_SLHC) += slhc.o
obj-$(CONFIG_DUMMY) += dummy.o
obj-$(CONFIG_IFB) += ifb.o