brocade: Convert uses of __constant_<foo> to <foo>
The use of __constant_<foo> has been unnecessary for quite awhile now.
Make these uses consistent with the rest of the kernel.
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/brocade/bna/bnad.c b/drivers/net/ethernet/brocade/bna/bnad.c
index aeec9cc..cb76253 100644
--- a/drivers/net/ethernet/brocade/bna/bnad.c
+++ b/drivers/net/ethernet/brocade/bna/bnad.c
@@ -2845,13 +2845,11 @@
}
if (unlikely((gso_size + skb_transport_offset(skb) +
tcp_hdrlen(skb)) >= skb->len)) {
- txqent->hdr.wi.opcode =
- __constant_htons(BNA_TXQ_WI_SEND);
+ txqent->hdr.wi.opcode = htons(BNA_TXQ_WI_SEND);
txqent->hdr.wi.lso_mss = 0;
BNAD_UPDATE_CTR(bnad, tx_skb_tso_too_short);
} else {
- txqent->hdr.wi.opcode =
- __constant_htons(BNA_TXQ_WI_SEND_LSO);
+ txqent->hdr.wi.opcode = htons(BNA_TXQ_WI_SEND_LSO);
txqent->hdr.wi.lso_mss = htons(gso_size);
}
@@ -2865,7 +2863,7 @@
htons(BNA_TXQ_WI_L4_HDR_N_OFFSET(
tcp_hdrlen(skb) >> 2, skb_transport_offset(skb)));
} else {
- txqent->hdr.wi.opcode = __constant_htons(BNA_TXQ_WI_SEND);
+ txqent->hdr.wi.opcode = htons(BNA_TXQ_WI_SEND);
txqent->hdr.wi.lso_mss = 0;
if (unlikely(skb->len > (bnad->netdev->mtu + ETH_HLEN))) {
@@ -2876,11 +2874,10 @@
if (skb->ip_summed == CHECKSUM_PARTIAL) {
u8 proto = 0;
- if (skb->protocol == __constant_htons(ETH_P_IP))
+ if (skb->protocol == htons(ETH_P_IP))
proto = ip_hdr(skb)->protocol;
#ifdef NETIF_F_IPV6_CSUM
- else if (skb->protocol ==
- __constant_htons(ETH_P_IPV6)) {
+ else if (skb->protocol == htons(ETH_P_IPV6)) {
/* nexthdr may not be TCP immediately. */
proto = ipv6_hdr(skb)->nexthdr;
}
@@ -3062,8 +3059,7 @@
vect_id = 0;
BNA_QE_INDX_INC(prod, q_depth);
txqent = &((struct bna_txq_entry *)tcb->sw_q)[prod];
- txqent->hdr.wi_ext.opcode =
- __constant_htons(BNA_TXQ_WI_EXTENSION);
+ txqent->hdr.wi_ext.opcode = htons(BNA_TXQ_WI_EXTENSION);
unmap = &unmap_q[prod];
}