Documentation: usb: gadget_serial: update generic serial setup instruction
Using module parameters to specify accepted Vendor ID, Product ID is
considered legacy now. Update the documentation to reflect it.
Signed-off-by: Andrzej Pietrasiewicz <andrzej.p@samsung.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/Documentation/usb/gadget_serial.txt b/Documentation/usb/gadget_serial.txt
index 61e67f6..6b4a88a 100644
--- a/Documentation/usb/gadget_serial.txt
+++ b/Documentation/usb/gadget_serial.txt
@@ -236,8 +236,12 @@
E: Ad=81(I) Atr=02(Bulk) MxPS= 512 Ivl=0ms
E: Ad=02(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms
-You must explicitly load the usbserial driver with parameters to
-configure it to recognize the gadget serial device, like this:
+You must load the usbserial driver and explicitly set its parameters
+to configure it to recognize the gadget serial device, like this:
+
+ echo 0x0525 0xA4A6 >/sys/bus/usb-serial/drivers/generic/new_id
+
+The legacy way is to use module parameters:
modprobe usbserial vendor=0x0525 product=0xA4A6