diff --git a/drivers/net/chelsio/my3126.c b/drivers/net/chelsio/my3126.c
index 82fed1d..87dde3e 100644
--- a/drivers/net/chelsio/my3126.c
+++ b/drivers/net/chelsio/my3126.c
@@ -10,25 +10,25 @@
 	 * This can be done through registers.  It is not required since
 	 * a full chip reset is used.
 	 */
-	return (0);
+	return 0;
 }
 
 static int my3126_interrupt_enable(struct cphy *cphy)
 {
 	schedule_delayed_work(&cphy->phy_update, HZ/30);
 	t1_tpi_read(cphy->adapter, A_ELMER0_GPO, &cphy->elmer_gpo);
-	return (0);
+	return 0;
 }
 
 static int my3126_interrupt_disable(struct cphy *cphy)
 {
 	cancel_rearming_delayed_work(&cphy->phy_update);
-	return (0);
+	return 0;
 }
 
 static int my3126_interrupt_clear(struct cphy *cphy)
 {
-	return (0);
+	return 0;
 }
 
 #define OFFSET(REG_ADDR)    (REG_ADDR << 2)
@@ -102,7 +102,7 @@
 
 static int my3126_set_loopback(struct cphy *cphy, int on)
 {
-	return (0);
+	return 0;
 }
 
 /* To check the activity LED */
@@ -146,7 +146,7 @@
 	if (fc)
 		*fc = PAUSE_RX | PAUSE_TX;
 
-	return (0);
+	return 0;
 }
 
 static void my3126_destroy(struct cphy *cphy)
@@ -177,7 +177,7 @@
 	INIT_DELAYED_WORK(&cphy->phy_update, my3216_poll);
 	cphy->bmsr = 0;
 
-	return (cphy);
+	return cphy;
 }
 
 /* Chip Reset */
@@ -198,7 +198,7 @@
 	val |= 0x8000;
 	t1_tpi_write(adapter, A_ELMER0_GPO, val);
 	udelay(100);
-	return (0);
+	return 0;
 }
 
 struct gphy t1_my3126_ops = {
diff --git a/drivers/net/chelsio/vsc7326.c b/drivers/net/chelsio/vsc7326.c
index 3355441..8c4a31e 100644
--- a/drivers/net/chelsio/vsc7326.c
+++ b/drivers/net/chelsio/vsc7326.c
@@ -256,7 +256,7 @@
 	else if((result & (1<<8)) != 0x0)
 		CH_ERR("bist read error: 0x%x\n", result);
 
-	return(result & 0xff);
+	return (result & 0xff);
 }
 
 static int bist_wr(adapter_t *adapter, int moduleid, int address, int value)
@@ -286,7 +286,7 @@
 	else if((result & (1<<26)) != 0x0)
 		CH_ERR("bist write error: 0x%x\n", result);
 
-	return(0);
+	return 0;
 }
 
 static int run_bist(adapter_t *adapter, int moduleid)
@@ -295,7 +295,7 @@
 	(void) bist_wr(adapter,moduleid, 0x00, 0x02);
 	(void) bist_wr(adapter,moduleid, 0x01, 0x01);
 
-	return(0);
+	return 0;
 }
 
 static int check_bist(adapter_t *adapter, int moduleid)
@@ -309,14 +309,14 @@
 	if ((result & 3) != 0x3)
 		CH_ERR("Result: 0x%x  BIST error in ram %d, column: 0x%04x\n",
 			result, moduleid, column);
-	return(0);
+	return 0;
 }
 
 static int enable_mem(adapter_t *adapter, int moduleid)
 {
 	/*enable mem*/
 	(void) bist_wr(adapter,moduleid, 0x00, 0x00);
-	return(0);
+	return 0;
 }
 
 static int run_bist_all(adapter_t *adapter)
@@ -358,7 +358,7 @@
 	udelay(300);
 	vsc_write(adapter, REG_MEM_BIST, 0x0);
 	mdelay(10);
-	return(0);
+	return 0;
 }
 
 static int mac_intr_handler(struct cmac *mac)