brcmfmac: Fix reconnect failure after beacon timeout
The DISASSOC command needs to be sent to firmware when a connection
loss is detected by firmware (e.g., beacon timeout). Otherwise the
next connect request fails due to a lingering LINK(down) event from
firmware. This patch resolves the issue by using brcmf_link_down()
handler, instead of the incomplete duplicated codes.
Reviewed-by: Arend Van Spriel <arend@broadcom.com>
Reviewed-by: Pieter-Paul Giesberts <pieterpg@broadcom.com>
Reviewed-by: Hante Meuleman <meuleman@broadcom.com>
Signed-off-by: Daniel Kim <dekim@broadcom.com>
Signed-off-by: Arend van Spriel <arend@broadcom.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/brcm80211/brcmfmac/wl_cfg80211.c b/drivers/net/wireless/brcm80211/brcmfmac/wl_cfg80211.c
index a91514a..e9d7413 100644
--- a/drivers/net/wireless/brcm80211/brcmfmac/wl_cfg80211.c
+++ b/drivers/net/wireless/brcm80211/brcmfmac/wl_cfg80211.c
@@ -4687,7 +4687,6 @@
struct brcmf_cfg80211_profile *profile = &ifp->vif->profile;
struct ieee80211_channel *chan;
s32 err = 0;
- u16 reason;
if (brcmf_is_apmode(ifp->vif)) {
err = brcmf_notify_connect_status_ap(cfg, ndev, e, data);
@@ -4708,16 +4707,6 @@
brcmf_dbg(CONN, "Linkdown\n");
if (!brcmf_is_ibssmode(ifp->vif)) {
brcmf_bss_connect_done(cfg, ndev, e, false);
- if (test_and_clear_bit(BRCMF_VIF_STATUS_CONNECTED,
- &ifp->vif->sme_state)) {
- reason = 0;
- if (((e->event_code == BRCMF_E_DEAUTH_IND) ||
- (e->event_code == BRCMF_E_DISASSOC_IND)) &&
- (e->reason != WLAN_REASON_UNSPECIFIED))
- reason = e->reason;
- cfg80211_disconnected(ndev, reason, NULL, 0,
- GFP_KERNEL);
- }
}
brcmf_link_down(ifp->vif);
brcmf_init_prof(ndev_to_prof(ndev));