net: dsa: fix preparation of a port STP update
Because of the default 0 value of ret in dsa_slave_port_attr_set, a
driver may return -EOPNOTSUPP from the commit phase of a STP state,
which triggers a WARN() from switchdev.
This happened on a 6185 switch which does not support hardware bridging.
Reported-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Vivien Didelot <vivien.didelot@savoirfairelinux.com>
Acked-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/dsa/slave.c b/net/dsa/slave.c
index 04f0153..7b1d9ec 100644
--- a/net/dsa/slave.c
+++ b/net/dsa/slave.c
@@ -453,12 +453,17 @@
struct switchdev_attr *attr,
struct switchdev_trans *trans)
{
- int ret = 0;
+ struct dsa_slave_priv *p = netdev_priv(dev);
+ struct dsa_switch *ds = p->parent;
+ int ret;
switch (attr->id) {
case SWITCHDEV_ATTR_PORT_STP_STATE:
- if (switchdev_trans_ph_commit(trans))
- ret = dsa_slave_stp_update(dev, attr->u.stp_state);
+ if (switchdev_trans_ph_prepare(trans))
+ ret = ds->drv->port_stp_update ? 0 : -EOPNOTSUPP;
+ else
+ ret = ds->drv->port_stp_update(ds, p->port,
+ attr->u.stp_state);
break;
default:
ret = -EOPNOTSUPP;