[PATCH] swsusp: debugging
Add a swsusp debugging mode. This does everything that's needed for a suspend
except for actually suspending. So we can look in the log messages and work
out a) what code is being slow and b) which drivers are misbehaving.
(1)
# echo testproc > /sys/power/disk
# echo disk > /sys/power/state
This should turn off the non-boot CPU, freeze all processes, wait for 5
seconds and then thaw the processes and the CPU.
(2)
# echo test > /sys/power/disk
# echo disk > /sys/power/state
This should turn off the non-boot CPU, freeze all processes, shrink
memory, suspend all devices, wait for 5 seconds, resume the devices etc.
Cc: Pavel Machek <pavel@ucw.cz>
Cc: Stefan Seyfried <seife@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/Documentation/power/interface.txt b/Documentation/power/interface.txt
index a66bec2..74311d7 100644
--- a/Documentation/power/interface.txt
+++ b/Documentation/power/interface.txt
@@ -30,6 +30,17 @@
that is known a priori. But, the user may choose 'shutdown' or
'reboot' as alternatives.
+Additionally, /sys/power/disk can be used to turn on one of the two testing
+modes of the suspend-to-disk mechanism: 'testproc' or 'test'. If the
+suspend-to-disk mechanism is in the 'testproc' mode, writing 'disk' to
+/sys/power/state will cause the kernel to disable nonboot CPUs and freeze
+tasks, wait for 5 seconds, unfreeze tasks and enable nonboot CPUs. If it is
+in the 'test' mode, writing 'disk' to /sys/power/state will cause the kernel
+to disable nonboot CPUs and freeze tasks, shrink memory, suspend devices, wait
+for 5 seconds, resume devices, unfreeze tasks and enable nonboot CPUs. Then,
+we are able to look in the log messages and work out, for example, which code
+is being slow and which device drivers are misbehaving.
+
Reading from this file will display what the mode is currently set
to. Writing to this file will accept one of
@@ -37,6 +48,8 @@
'platform'
'shutdown'
'reboot'
+ 'testproc'
+ 'test'
It will only change to 'firmware' or 'platform' if the system supports
it.