USB: ehci: phy low power mode bug fixing
1. There are two msleep calls inside two spin lock sections, need to unlock
and lock again after msleep.
2. Save a extra status reg setting.
Signed-off-by: Alek Du <alek.du@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/usb/host/ehci-hub.c b/drivers/usb/host/ehci-hub.c
index c75d927..1937267 100644
--- a/drivers/usb/host/ehci-hub.c
+++ b/drivers/usb/host/ehci-hub.c
@@ -196,7 +196,9 @@
if (hostpc_reg) {
u32 t3;
+ spin_unlock_irq(&ehci->lock);
msleep(5);/* 5ms for HCD enter low pwr mode */
+ spin_lock_irq(&ehci->lock);
t3 = ehci_readl(ehci, hostpc_reg);
ehci_writel(ehci, t3 | HOSTPC_PHCD, hostpc_reg);
t3 = ehci_readl(ehci, hostpc_reg);
@@ -904,17 +906,18 @@
if ((temp & PORT_PE) == 0
|| (temp & PORT_RESET) != 0)
goto error;
- ehci_writel(ehci, temp | PORT_SUSPEND, status_reg);
+
/* After above check the port must be connected.
* Set appropriate bit thus could put phy into low power
* mode if we have hostpc feature
*/
+ temp &= ~PORT_WKCONN_E;
+ temp |= PORT_WKDISC_E | PORT_WKOC_E;
+ ehci_writel(ehci, temp | PORT_SUSPEND, status_reg);
if (hostpc_reg) {
- temp &= ~PORT_WKCONN_E;
- temp |= (PORT_WKDISC_E | PORT_WKOC_E);
- ehci_writel(ehci, temp | PORT_SUSPEND,
- status_reg);
+ spin_unlock_irqrestore(&ehci->lock, flags);
msleep(5);/* 5ms for HCD enter low pwr mode */
+ spin_lock_irqsave(&ehci->lock, flags);
temp1 = ehci_readl(ehci, hostpc_reg);
ehci_writel(ehci, temp1 | HOSTPC_PHCD,
hostpc_reg);